Hi all
Are convertible sills different from the 2 door? I thought they were deeper but they are listed on carpanels.com with the same part no. for both.
i'm weighing up whether to repair or do properly and fit sills, assuming I can find them.
1988 Convertible sills
Moderator: martauto
-
andysheep
- E30 Zone Regular

- Posts: 444
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Abersoch north wales
There different,for sure ,but panel seller keep doing it ,with rear archs too,beware 
-
Dlb26
- E30 Zone Newbie

- Posts: 206
- Joined: Fri Jan 08, 2016 11:00 pm
Looks like repair then, not too bad (on the surface
) small hole around factory jacking point on drivers side only and tatty elsewhere
-
andysheep
- E30 Zone Regular

- Posts: 444
- Joined: Sun Jul 12, 2009 11:00 pm
- Location: Abersoch north wales
Metal thicker too to compensate for no roof,and there rot at the jacking point cos jacking scrapes the stone chip off i think ,all four of mine need major work,and the rear quarters are thicker gauge too i believe,easer to weld 
