Crush Washers (P/steering)

Post Mon Feb 09, 2015 1:05 pm

Any chance of obtaining the part no. Of the 16mm crush washer (pt 5) on Realoem. Dealers can't locate it and service dept can't find it without pt no.

It must exist and at the moment I'm at a dead end.

Post Mon Feb 09, 2015 1:46 pm

If you have the old one (assuming it's copper ) heat it till bright red with a blowlamp then dip it in water then simply refit - I've done this many times and it's never leaked

Post Mon Feb 09, 2015 2:15 pm

[quote="Ianb"]If you have the old one (assuming it's copper ) heat it till bright red with a blowlamp then dip it in water then simply refit - I've done this many times and it's never leaked[/quote

Agreed with annealing copper but these are aluminium. Can source the 14mm washers (have pt. no.) but the 16mm doesn't exist, crazy!!

Post Mon Feb 09, 2015 3:20 pm

Funnily enough I'm just about to order them, the 16mm washer is, I think, 32411093597

Post Mon Feb 09, 2015 4:27 pm

jslot wrote:Funnily enough I'm just about to order them, the 16mm washer is, I think, 32411093597

Thanks for that, your right. Checked out that no. On realoem and it describes part for 325ix. Back to the stealers for some. Thanks again

Post Tue Feb 10, 2015 8:47 am

To you guys these are £1 each

Sorry for the late reply

James