Where do the heater matrix o-rings go/leak

[appletree]

Just looking at replacing these o-rings while the carpets out, i'm talking my self in to doing them but just to make sure where do they go and does this look like it might be or have leaked from where they go? i don't have a wet carpet at the minute but there is anti freeze type coloring around the joints.






Sorry there not the best quality pics..

Also is there as seal between part 7 and the matrix its self?

[Jona1971]

yes, I think its the same as part 8 - as you need 2 of them.

[BenHar]

They usually leak on part 7. You can see the start of it in your picture where the white scale is showing.

I repaired mine with a couple of O-rings.

I worked out what was needed from here: http://translate.google.co.uk/translate ... 6bih%3D880

Ben

[capri_rob]

Or the valve itself also leaks. I've done mine recently it's not too bad of a job.

[appletree]

They usually leak on part 7. You can see the start of it in your picture where the white scale is showing.

I repaired mine with a couple of O-rings.

I worked out what was needed from here: http://translate.google.co.uk/translate ... 6bih%3D880

Ben

Part 7 as in where the valve goes in with the 4 bolts to the tube bit? There is no oring showing on the real oem picture for that position though is there? Is it on another page?

[appletree]

Sorry, just seen the link, as its riveted there not realy a maintance item I take it.. did you change an oring/ gasket on the end of part 7, the flat flange with the to bolt holes is?

[BenHar]

Sorry, just seen the link, as its riveted there not realy a maintance item I take it.. did you change an oring/ gasket on the end of part 7, the flat flange with the to bolt holes is?

Yes, it's an o-ring. Same as part nomber 8.

Ben