As per the above;
I'm going to be machine polishing the old girl, (the car, that is, not SWMBO!) and am intending removing the existing badge.
I don't want to faff about removing the old adhesive foam stuff, and then cutting minute pieces of new double sided tarp to fit.
Will I have to source one from a Main Stealer, as I can't see any on fleabay, or is there any another source I can use?
Thanks
Andy
E30 '320i' rear badge - where to obtain one?
Moderator: martauto
-
Speedtouch
- Old Skooler

- Posts: 14030
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Sometimes, you can remove the badge by heating it with a hair dryer to loosen the adhesive then using thin fishing line to prize it off.
Then stick some cellophane over it to prevent dust getting on.
Cotswolds on here would probably be able to supply a new one, if required.
Then stick some cellophane over it to prevent dust getting on.
Cotswolds on here would probably be able to supply a new one, if required.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Very often the dealer is cheaper than the 'bay, especially where badges and clips are concerned. Contact Cotswolds, and you'll be pleasantly surprised.rtz62 wrote:Will I have to source one from a Main Stealer, as I can't see any on fleabay
'89 325i Touring | Touring Resto Thread | In-Dash Screen install

