clutch fluid leaking
Moderator: martauto
-
fuzzy
- He who sleeps with "Gingers"
- Posts: 14351
- Joined: Sat Jun 04, 2005 11:00 pm
- Location: melbourne Australia
hi folks, driving home last night i found a wet patch on my drivers side floor mat. the clutch fluid is dripping of the pedal. is there a common thing to look for before i go and tackle it?
-
magnumlove
- E30 Zone Newbie

- Posts: 61
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Ipswich
it's probally your clutch master cylinder leaking.
-
gcorky
- Boost Junkie
- Posts: 2009
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: n.e england
-
89Cabreeo
- E30 Zone Newbie

- Posts: 16
- Joined: Sat Jan 21, 2006 11:00 pm
- Location: Tucson, Arizona, USA
That's exactly what it is based upon my unfortunate experience. If you're going to repair yourself you'll need a chiropractor when you're done because getting to the master cylinder is really awkward. Good Luck

89 325i Cabrio, Tucson, Arizona, USA
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Take the driver's seat out. Makes working there a lot easier, and the loose change you find will go a little way towards paying for the new cylinder.
-
Ziggy
- E30 Zone Team Member

- Posts: 11534
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: floating round my tin can...
Blimey, don't get scared here - it's an easy job!
Just make sure you do the slave at the same time or you'll have problems again in the near future...
E30 in need of wiring loom smoke since April '11...
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Job's easy, access is not.Ziggy wrote:Blimey, don't get scared here - it's an easy job!Just make sure you do the slave at the same time or you'll have problems again in the near future...
Slave won't neccessarily fail following a M/C change. It's when the slave fails and the M/C moves slightly further in the bore than it does normally that the M/C fails right after.
-
Ziggy
- E30 Zone Team Member

- Posts: 11534
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: floating round my tin can...
Fairy nuff - I'd just heard the stories of one causing t'other to fail & figured it was worth doing both...
Took me about 45 mins from start to finish, but seat-out's a good idea for next time 
E30 in need of wiring loom smoke since April '11...

