Ok so I was wondering if anyone had any info on putting an E21 323i cam in an 885 head?
I heard about this a few years back but wasn't interested at the time and I can't remember the details about it.
E21 323i cam into 885 head
Moderator: martauto
-
HairyScreech
- Engaged to the E30 Zone
- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
I have the cam profiles on file somewhere and without digging them out there is really very little between them.
So little it is not worth the time and effort to swap them over. I think from memory the difference was about 5 degrees duration and the integral of the time/lift was pretty much identical.
So little it is not worth the time and effort to swap them over. I think from memory the difference was about 5 degrees duration and the integral of the time/lift was pretty much identical.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
-
Dixonzerstorer
- E30 Zone Newbie
- Posts: 5
- Joined: Fri Mar 26, 2010 11:00 pm
So not worth swapping but if you had both to hand and you were building from scratch the 323i would be a little bit better?
Thanks for the info as well bud
Thanks for the info as well bud