Distributor cap and rotor - aftermarket quality??

Post Sun Jun 22, 2014 4:06 pm

Hi all,

Checked my distributor cap and rotor arm today and they definitely need replacing, points very corroded.

I had a look on GSF and ECP but they only supply aftermarket 'BERU' products. Can anybody advise about the quality of them?

Going to ask BMW Cotswold for a quote also, other than that can any body direct me to some where selling Bosch products? Can only find on ebay.

Post Sun Jun 22, 2014 5:01 pm

BERU are the OEM manufacturer for BMW.

Post Sun Jun 22, 2014 5:03 pm

Grrrmachine wrote:BERU are the OEM manufacturer for BMW.

As above.

Replaced mine with Beru parts a few years back and faultless service since.

Post Sun Jun 22, 2014 5:23 pm

darkchild wrote:
Grrrmachine wrote:BERU are the OEM manufacturer for BMW.
As above.

Replaced mine with Beru parts a few years back and faultless service since.

Where did you buy your BERU parts from?

Post Sun Jun 22, 2014 10:29 pm

bosch and bremi also do dizzys and rotors, the bosch one has been faultless for me

Post Mon Jun 23, 2014 11:29 am

RobWill116 wrote:
darkchild wrote:
Grrrmachine wrote:BERU are the OEM manufacturer for BMW.
As above.

Replaced mine with Beru parts a few years back and faultless service since.
Where did you buy your BERU parts from?

I purchased mine from Motormec when they were based in Lowestoft. They've since been taken over and have an outlet in Norwich but I haven't used them since the change of ownership.

Post Mon Jun 23, 2014 9:49 pm

Cheers, found a supplier on the bay. Got BERU distributor cap and rotor on its way