Propshaft
Moderator: martauto
-
jasso
- E30 Zone Regular
- Posts: 531
- Joined: Tue Mar 28, 2006 11:00 pm
Hi guys just finishing my e30 330d I know it's not everyone's choice but oh well, looking for someone to do a custom propshaft ideally close to the West Midlands?[/list]
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Search out a kit car forum. They should be able to help you.
-
Rav335uk
- E30 Zone Meets/Events Team
- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
jasso
- E30 Zone Regular
- Posts: 531
- Joined: Tue Mar 28, 2006 11:00 pm
I am going to see davemacprops on the weekend, but spoke to a few peps that are saying that they welded there's up with a mig welder is this safe?? 
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Depends how good the man holding the torch is.
-
HairyScreech
- Engaged to the E30 Zone
- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
Should be fine provided its a good constant full penetration weld. Pretty much all props are welded like that in mass production.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
-
jasso
- E30 Zone Regular
- Posts: 531
- Joined: Tue Mar 28, 2006 11:00 pm
I thought propshafts are friction welded