so acording to a friend who has had 4 325is they have bolt on slam pannels but mine which was a 316i is welded.
how did bmw decide which would be bolt on and welded?
and how easy would it be to make min into a bolt on slam panel is it a case of cutting it off drilling 4 holes and putting 25mm bolts in and henching them up tight?
would my MOT tester/VOSA have anything to say about this? (who actually care about VOSA)
slam panels
Moderator: martauto
-
e30topless
- E30 Zone Team Member
- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
they are all spot welded in place, why would you need to bolt one on ?
-
ejoeyward
- E30 Zone Newbie
- Posts: 75
- Joined: Mon Apr 28, 2014 11:00 pm
to make it easier to pull my engine which happens quite often when me and my mates are bored and havnt got anything to do
-
Rav335uk
- E30 Zone Meets/Events Team
- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL