budget touring trackday/drift project

[shedrool83]

Looks familiar

Looked good in the pictures so just copied it

[shedrool83]

Seats arrived



Will get them mounted and weld in a rear strut brace over the weekend to take the harnesses .

[DanThe]

I would get those pointy bits cut off Jake, looks dangerous to me!

[shedrool83]

Yeah Dan they are going they end up right behind the seat and i don't fancy them in the back.

[shedrool83]

Paint brush was out today





Hoping to get this fitted soon

[shedrool83]

Got the 4mm polycarbonate windows in the 4 doors, 3mm pvc foam door cards, carbon wrapped the panel under the heater controls and carbon wrapped a blank for the clock hole.

Had wrap spare so tried a door handle too.

[Jimbob]

If you find the footwells a bit slippy, skateboard tape helps!

[shedrool83]

If you find the footwells a bit slippy, skateboard tape helps!

I have foot plates for the drivers and passenger side on order but good tip .

[G-Bear]

Enjoying this build. Like where you placed the check panel in the dash..

[shedrool83]

Enjoying this build. Like where you placed the check panel in the dash..

Cheers

[shedrool83]

Fitted some footrests and a battery gauge





Also wrapped the rest of the door handles with the spare 3m 3d carbon i had lying about.



I have ordered so 4d carbon wrap for the bonnet and tailgate so thats this weekends project then its time to start saving for gaz coilovers

[shedrool83]

Went a bit mental with the carbon wrap

[rix313]

Looks much better than my attempts what wrap did you use?

[shedrool83]

Looks much better than my attempts what wrap did you use?

Just cheap stuff off ebay

http://www.ebay.co.uk/itm/NEW-Black-4D- ... 27d75d1f1c

I'm happy with the results ,it's not perfect but was my first time and it will do the job.


Just done the bump strips while i was watching the city game

[shedrool83]

[NoTurbo]

This looks like my kinda thread. I am interested in some engine pics if possible and I can't wait to see how you sort out the cage.