retro Fitting heated seat kit

[sweep]

As above from fitting the elements to the wiring in.

[dusty23]

There was a guide linked or on here at some point, I think ratch linked it or mentioned it

[pacerpete]

Pete, you must be VERY bored !

[bss325i]

Loom and switches are the easy bit. Loom plugs into the socket behind the glove box and routes down to seats.

Seats require total strip down!

[bmwe30mtech]

You can actually fit into the seats quite easily. Just remove the seat back from the base, and then unpin the squabs at either end. Then sticky tape each length of heating element onto the end of a flexible 30cm ruler and slide them down the inside of the squab, between the two layers of fabric. Takes about 3 hours to do both seats carefully.

[bss325i]

You can actually fit into the seats quite easily. Just remove the seat back from the base, and then unpin the squabs at either end. Then sticky tape each length of heating element onto the end of a flexible 30cm ruler and slide them down the inside of the squab, between the two layers of fabric. Takes about 3 hours to do both seats carefully.

Saloon seat yes, cabrio or M3 seat no.

[sweep]

I have sportz seats...very busy at minute pete moving garage..

[Jozi]

I'd love to know how easy or hard it is to do this with Recaro Ls' and if it wasn't an option are there after market kits that will fit?

[Cloggy Saint]

My recaros are heated so there must be an available kit.