325i Exhausts

Post Mon Dec 02, 2013 4:35 pm

So knowing that I am replacing my exhaust in February, I was wondering if anyone had some advice.

1986 325i Cabby...

I am looking into fitting a full scorpion system but noticed that the post 88' is half the price of the pre 88' system, why?

Any other suggestions?

Thanks

Post Mon Dec 02, 2013 4:52 pm

DO NOT FIT A SCORPION !!!!!!!!

Post Mon Dec 02, 2013 6:26 pm

Ok!!!!!

So what do suggest instead?

Post Mon Dec 02, 2013 6:57 pm

jetex used to do a nice system for the early cars at a reasonable price. Scorpion are crap and tend to fail internally.

Post Sun Dec 08, 2013 11:00 pm

I put a eberspacher rear exhaust on this summer.. Very pleased with it. There were two options I went for the dearer one... You get what you pay for.

Post Mon Dec 09, 2013 12:44 am

Gavla wrote:I am looking into fitting a full scorpion system but noticed that the post 88' is half the price of the pre 88' system, why?

Because the earlier system is a 3 piece system and the later one a two piece.

Post Mon Dec 09, 2013 5:18 pm

G-Bear wrote:I put a eberspacher rear exhaust on this summer.. Very pleased with it. There were two options I went for the dearer one... You get what you pay for.

Sounds good, can you pm me all the details...

Post Mon Dec 09, 2013 5:24 pm

Yeah I can dig up the invoice later with the part number. However, my exhaust is a two part exhaust do you know what yours is?

From reading the post in this thread I assume yours is a three part.

Post Mon Dec 09, 2013 11:39 pm

Yip it is, where did you get yours, I will give them a call...