My exhaust is banging against the valance, and the back box seems pressed up against the spare wheel well. This means I get a really throaty rumble through the car between 1500-2000 RPM, which is starting to get on my tits...
Car's a 325i Touring with a catalyzer system. All the exhaust mounts and rubbers are in good condition and bolted up firmly, but I can't work out how to adjust anything to move the exhaust over an inch.
Adjusting exhaust
Moderator: martauto
-
Grrrmachine
- E30 Zone Wiki / Team Member
- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Speedtouch
- Old Skooler
- Posts: 14123
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Sounds like you may need to either bend the mounting brackets, or fit longer rubbers.
Either that, or fit a sneaky length of wire to pull it over a bit.
Either that, or fit a sneaky length of wire to pull it over a bit.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
-
Grrrmachine
- E30 Zone Wiki / Team Member
- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Yeah, it's all in the rear hangers, I should have realised. Loosened them up and twisted them round so that they were pulling the exhaust over rather than just letting it hang down. 
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Speedtouch
- Old Skooler
- Posts: 14123
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
Where there's a will, there's a way, especially if you're Polish!
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421