Which is a better?

[SAP1]

I have a small amount of rust on my inner wing that needs cleaning up. Which one is better to remove the rust and it get back to bare metal


http://www.ebay.co.uk/itm/Bilt-Hamber-D ... 2a3218b33e


http://www.ebay.co.uk/itm/HAMMERITE-KUR ... 53fddb2090

http://www.ebay.co.uk/itm/Fertan-Rust-K ... 19e0471836

Many thanks

[Speedtouch]

I would recommend Jenolite.

[SAP1]

This stuff?

http://www.ebay.co.uk/itm/Jenolite-Rust ... 3a82fcd66a

[mercdriver]

Angle grinder, plate, mig, paint...

Jenolite is good stuff (wear gloves)

[mercdriver]

Angle grinder, plate, mig, paint...

Jenolite is good stuff (wear gloves)

[polsta]

Angle grinder, plate, mig, paint...

Jenolite is good stuff (wear gloves)

this !!

fertan/kurust isnt really a "rust remover" its more a converter and a preventor, rust in them areas needs to be properly removed and cut out like a cancer

[Speedtouch]

Yes, with Jenolite, it's an acid - you brush it on, leave it for a few minutes, brush on another thin coat then wipe it off to leave clean metal.

My brother tried it on a bonnet that had some paint stripped off and been left out to rust for months; a quick once-over with the Jenolite and some wire wool brought it up shiny again!

As above, with the Kurust and Fertan products, you are left with a bluish coating on the treated area.

[harry_p]

Hamerite do a proper rust remover gel too which works quite well. Not as pod as jenolite, but its a lot less nasty if you accidentally splash it on yourself, your clothes or other bits of your car.

Really you should remove as much as possible, either with gels or physical removal, and then use kurust or similar to kill / slow down the spread of any tiny bits too small to see.

[Speedtouch]

This stuff?

http://www.ebay.co.uk/itm/Jenolite-Rust ... 3a82fcd66a

That's the stuff. Also available in most good motor factors, Halfords, etc.

Be very careful not to get any in your eyes - wear goggles, and gloves.

[adit]

SAP1, what on earth would anyone on here know about rust??

[SAP1]

Thanks for the advice Jenolite it is then! Adit most E30's are rust free you should know that

[Gavla]

I have converted to Bilthamber products, they do what they say on the tin and I would never go back to any other product.

[adit]

I have converted to Bilthamber products, they do what they say on the tin and I would never go back to any other product.

it certainly sounds like it does a proper job:

http://www.bilthamber.com/corrosion-treatments

[Jozi]

I've used bilthamber in my build it is good stuff, curious about that jenolite it also sounds good.

[maggspower]

I have been using the bilt hamber stuff for years. Its good in the right areas. I have just derusted a motorcycle tank. Put some Deox-C in there left it for a few days, "Bang, and the rust is gone"

The gel is ok too, it all works, but it takes time. Sometimes a flap wheel on a grinder is the best tool for the job, there is more than one way............ as they say.