putting together the clutch and flywheel in a m52 swap HELP!

[breakermart]

ok iv got
M52B28 engine from a 5 series auto..
Manual gearbox from a 2.8 E36..
iv just bought a flywheel from a M20..
matching starter motor on its way..

do I have to buy a clutch that is for the m52b28 or one that's for a m20b25?

and wich spigot bearing do I use?

finaly, is there anything else I need to do. iv heard about spacers and also something about removing some metal from the flywheel.... im a bit confused!!! if somebody could explain whats needed like im 5 years old lol then that would be great.

[maggspower]

Clutch needs to be the m20b25 item. Sachs ones are cheap at carparts4less.

You will need, m52b28 spigot bearing, although I think they are all the same.

[breakermart]

ok that answers that perfectly thankyou

[DanThe]

If its a ZF E36 box you will need a 15mm spigot bearing, the spacer/spreader plate goes between the flywheel and the bolts, to spread the load from the bolts.
The M20 flywheel will need to be machined/lightened to fit onto the M52 engine

[breakermart]

how much we talking about being machined off the flywheel then?
also spacer/spreader plate? im unsure what this is.
cheers
by the way danthe how much for the adaptor to make my loom fit the e30?

[DanThe]

Dont do adaptors mate, just do loom conversions so the loom fits the car in the same way an original E30 engine loom would

[breakermart]

ok il keep that in mind mate cheers

[AndyZippy]

Can definately recommend Dan's loom, simple as simple gets to fit