Washer fluid light
Moderator: martauto
-
Justin325i
- E30 Zone Regular
- Posts: 298
- Joined: Tue Jan 11, 2005 11:00 pm
The washer fluid light is showing on the check panel, tank was full but emptied it out cleaned the 'gunk' and re-filled with ready to use screen wash but light is still showing, can anyone advise.
'93 E30 325i Calypso Cab
-
BenHar
- E30 Zone Addict
- Posts: 3089
- Joined: Sun Jul 11, 2010 11:00 pm
- Location: Reigate, Surrey
washer AND fluid AND light
Put that in the search function.
Ben
Put that in the search function.
Ben
-
hennared323i
- Old Skooler
- Posts: 2349
- Joined: Wed Jul 25, 2007 11:00 pm
Was the sensor put back in upside down?
-
mng786
- E30 Zone Newbie
- Posts: 49
- Joined: Mon Feb 06, 2006 11:00 pm
- Location: ROMFORD ESSEX
Mine was doing the same thing.
Took the sensor out and it was covered in gunk.
So i cleaned it and put it back in.
Still the same! Then i noticed it was upside down.
Turned it around and BINGO...... Hasnt come back on
Since.
The outside of the sensor is round on 1 side and flat
On the other.
The flat side needs to be closest to the drivers side
Wing. (If that makes sense)
Took the sensor out and it was covered in gunk.
So i cleaned it and put it back in.
Still the same! Then i noticed it was upside down.
Turned it around and BINGO...... Hasnt come back on
Since.
The outside of the sensor is round on 1 side and flat
On the other.
The flat side needs to be closest to the drivers side
Wing. (If that makes sense)
-
Justin325i
- E30 Zone Regular
- Posts: 298
- Joined: Tue Jan 11, 2005 11:00 pm
The sensor in the tank was moving freely and outside the tank the pins are facing up so the flat side is facing towards the drivers' wing.
'93 E30 325i Calypso Cab
-
Justin325i
- E30 Zone Regular
- Posts: 298
- Joined: Tue Jan 11, 2005 11:00 pm
Found a break in the wiring
'93 E30 325i Calypso Cab