325i trim

[Jamboree]

I've taken trim of my front and rear bumpers for spraying plus grills unfortunately I've broken quite a few fixing supports will they still hold with only a few left or should I be trying to find new ones

[j2b]

Get some new ones , your bmw dealers will probably will be able to get them .

[Jamboree]

Couldn't I just put a dash off super glue where the tabs are broken to hold it in place new trim is well expensive

[ross_jsy]

Well this is a council fest.

Yes of course you can bodge it with superglue, but why not do it properly for the sake of a few quid?

[Jim320i]

Which parts have you broke exactly?

[daimlerman]

Which parts have you broke exactly?

Reads like the OP has levered the trim bits off without first removing the bumper to squeese the tabs in to me...

[Kedge]

Just buy good secondhand parts. Using superglue would be about the worst thing you could use to stick them back with as well.

[Jim320i]

Which parts have you broke exactly?

Reads like the OP has levered the trim bits off without first removing the bumper to squeese the tabs in to me...

Thats what I thought, if thats the case then has he damaged the rubber/plastic trim itself? If so, is it a pre or facelift car? And is it both front and back?

[Jamboree]

It's the plastic trim which you have to take of to remove the bumber the fasteners have been snapped ill just get the bloke to give them a scan if knackered hope he can get me a cheap set you boys think just a spot of glue to hold it is a bad idea I'm not going to drowned it in the stuff

[Kedge]

The little squares?? They are about 90p from BMW.

Super glue becomes brittle, you'd be better off using somekind of silicon sealer if you have to resort to sticking them in place.

[Jim320i]

What year is the car?

[Jamboree]

Daimlerman that's what I did levered of the trim with screwdriver I'm a novice carnt you tell i thought you had to take that trim off to remove the front bumber 1988

[Topblag]

Daimlerman that's what I did levered of the trim with screwdriver I'm a novice carnt you tell i thought you had to take that trim off to remove the front bumber 1988

What you need is a haynes manual and a few days in the wiki section. You're not the first and won't be the last. You can pick up bumper trim on here if you look often enough.

[Jamboree]

Cheers for yours words of wisdom anyone spare a few grand so I can get it how I want it