Hi all,
My M10 engined 316 is not blowing very warm air through the cabin. I've just flushed radiator, refilled with correct coolant/ water mix and changed the thermostat and the engine temp is now getting up to midway point fine but heater is pi55 poor. Does that sound like an airlock?
The bleeding procedure according to Haynes is just to squeeze the top hose to expel any air. Do I just keep doing that until it sorts itself? Any other tips?
Ta, Nick[/b]
Heater blowing cool
Moderator: martauto
-
Nick45
- E30 Zone Newbie
- Posts: 195
- Joined: Thu Jun 30, 2005 11:00 pm
- Location: Leeds
Carbs 'n Chrome
-
Nick45
- E30 Zone Newbie
- Posts: 195
- Joined: Thu Jun 30, 2005 11:00 pm
- Location: Leeds
Scratch the above chaps. After more squeezing and general pleasuring of the top hose, heater is now toasty. Yay.
Carbs 'n Chrome