Guys thinking about this
Anyone here or know anything info on this?
Or even can it be done?
535d conversion
Moderator: martauto
-
SHAZ325iSPORT
- E30 Zone Addict

- Posts: 2360
- Joined: Sat Mar 26, 2005 11:00 pm
- Location: East London
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Anything can be done with enough time and talent. In this case you'll need lots of both.
You're probably thinking of the M57TUD30 which is actually only a 3.0 diesel lump. This has been done, once, but I don't know anything about how. I can imagine that the electronics alone are phenomenally complex though (ECU will want to communicate with both the gearbox and diff, somehow).
Must ask - why?
You're probably thinking of the M57TUD30 which is actually only a 3.0 diesel lump. This has been done, once, but I don't know anything about how. I can imagine that the electronics alone are phenomenally complex though (ECU will want to communicate with both the gearbox and diff, somehow).
Must ask - why?
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
maxfield
- Old Skooler

- Posts: 15185
- Joined: Sat Nov 26, 2005 11:00 pm
- Location: Mansfield
300hp 500lb/ft and 40+mpgGrrrmachine wrote:Must ask - why?
Would be nice to see, a lot of work I imagine though.

-
verde
- Engaged to the E30 Zone

- Posts: 5438
- Joined: Thu Aug 25, 2011 11:00 pm
- Location: The Sticks
I would like to do similar with an E28, put a modern 525d lump in but again, it seems very complex
Marrakesh brown tech 2 LSx loading.....
Raise hell praise Dale.
North East Drift Club - Hollerboys Drift
Raise hell praise Dale.
North East Drift Club - Hollerboys Drift
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
The torque would be impressive, but I can't imagine how many miles you'd have to do to cover the cost of the conversion, and all the other mods you'd have to take advantage of those power figures.
And once you're on that sort of money, you might as well do it properly and ditch diesel altogether.
And once you're on that sort of money, you might as well do it properly and ditch diesel altogether.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
Much more than that!maxfield wrote:300hp 500lb/ft and 40+mpgGrrrmachine wrote:Must ask - why?
-
Phill172
- E30 Zone Camper

- Posts: 1117
- Joined: Wed Feb 20, 2008 11:00 pm
- Location: Basingstoke
No, the mpg figure is never near that.maxfield wrote:300hp 500lb/ft and 40+mpgGrrrmachine wrote:Must ask - why?
Would be nice to see, a lot of work I imagine though.
My commute to work, whilst driving a 535d was never more then 28mpg and a 2800 mile holiday to/around/from Austria (working out fuel/miles over the period) I only managed 34.8mpg.
Im sure sat at 60mph on a dual carriageway you can get 40+ but in the real world driving no
The engine is amazing, and to get the performance in a petrol you would be looking at alot lower mpg figures.
However in a light E30 id imagine the mpg would be very different!
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
My dads indicates an average of 40mpg+ whilst on the motorway.
34 in everyday driving mixture of dual carriageways and town.
Burnout is remapped
34 in everyday driving mixture of dual carriageways and town.
Burnout is remapped
-
BMW_E30vert
- E30 Zone Regular

- Posts: 705
- Joined: Thu Mar 11, 2010 11:00 pm
- Location: Greater London
i used to get close to 40mpg in mines on the motorway until the dpf filter got clogged up, my car went like stink i could only imagine how it would go in a e30. the later cars with the joystick gearbox had more bhp and were better on fuel aswell.
-
TheHeap
- E30 Zone Squatter

- Posts: 1749
- Joined: Wed Feb 25, 2009 11:00 pm
- Location: welling
Brilliant idea but quite expensive.

-
capnmchl
- E30 Zone Camper

- Posts: 1141
- Joined: Mon Feb 20, 2012 11:00 pm
- Location: Exeter, Devon
Reckon that's enough torque to start having problems with the diff mounting points?

