whats the best tool to romove the wire clips that hold the m20 injectors to the electrical block...
fuel rail/injectors are off the inlet manifold, but is not obvious how the injectors unclip
Thanks
injector removal
Moderator: martauto
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
It's a spring clip,if possible,work in a clean area so you can capture the little buggers as you ease them out with a small,flat bladed screwdriver.
Youth is wasted on the young.
-
steve_k
- E30 Zone Team Member
- Posts: 8044
- Joined: Fri May 23, 2008 11:00 pm
- Location: in the vale of mansfield
small flat blade screwdriver on one side hand at the ready on the other side for when it decides to go "fook you pal i'm off" & land somewhere you'll never find it 
if it's got t*ts or wheels it's bound to be trouble...............prove me wrong.
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
getting oral sex off an ugly person is like rock climbing.....don't look down ;)
-
mark_i
- E30 Zone Regular
- Posts: 972
- Joined: Thu Aug 10, 2006 11:00 pm
- Location: Widnes
thanks guys...all done.
Not the easiest job, its like the connectors were designed for fiiting injectors, not removing.
Off to Injector tune for a clean/refurb...
Not the easiest job, its like the connectors were designed for fiiting injectors, not removing.
Off to Injector tune for a clean/refurb...
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Put all the spring clips fully back in place before you refit the rail.
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Correct.mark_i wrote:
Not the easiest job, its like the connectors were designed for fitting injectors, not removing.
The rail just clips back on.