cam sync
Moderator: martauto
I think there is something available from Pure Performance Factory in Sweden.
However a simple 10mm flat ally plate can be cut/machined easy to replace the ignition cap, then drill and fit a hall effect or VR sensor and wire to the ecu.
Where the rotor used to bolt on there are threads, you can simply screw in a bolt there that will swing past the sensor within 1mm distance and thus get your trigger point.
However a simple 10mm flat ally plate can be cut/machined easy to replace the ignition cap, then drill and fit a hall effect or VR sensor and wire to the ecu.
Where the rotor used to bolt on there are threads, you can simply screw in a bolt there that will swing past the sensor within 1mm distance and thus get your trigger point.
-
Nobby_N
- Old Skooler
- Posts: 3957
- Joined: Sat Mar 24, 2007 11:00 pm
- Location: Boston Lincs Mainly being a Coont
Hey Gunni theres a pose out looking for you on this thread! keep ya nut down lol
http://www.e30zone.net/modules.php?name ... &start=250
http://www.e30zone.net/modules.php?name ... &start=250