My 328iS, and some booty :)

[Jordan]

Did a photoshoot last month, just now getting these pictures circulated up on this forum. Post comments and such. Yes my damn broken exhaust hanger has been since fixed!

[Jordan]

Mods list is as follows:

Engine:

Engine total displacement: 2759cc's

All new valve guides/seals
All new valves
All new rockers
3 Angle valve grind
JE 85mm Forged pistons 10.2:1 CR
TotalSeal piston rings
Lightweight wrist pins
81mm stroke crankshaft
Blueprinted & balanced bottom end
274/274 11.5mm lift Shrick camshaft
Heavily ported & polished head
Reshaped and highly polished combustion chambers
19lb Bosch Design II injectors
UniChip engine management
M52 HFM (MAF) conversion
Port matched intake manifold
Powder coated intake manifold
Powder coated valve cover
Custom CAI & heat shield
8mm red silicone ignition wires
173 DME Unit

Exterior:

Complete Lachssilber repaint (was Schwartz)
Fully custom fitted plastic bumper conversion
Painted euro bumper trim
EVO hood seals
Later style front valance (de-textured)
Rieger Infinity front lip spoiler
Custom front lip splitter
e36 328iS side skirts, custom fitted
e36 M3 rear lower bumper, highly modified
Shaved door locks
Shaved side moldings
Shaved antenna
Painted door handles
Euro headlight grills
M-Technic II rear wing
Full shadow line treatment
Non-Popout rear side window retrofit
Color matched kidneys

Drivetrain & Exhaust:

Stahl full length Jethot coated headers
Jethot coated catless midpipes
Brullen muffler, dual 3in round tips
Lightened stock single mass flywheel (12lbs)
6 puck unsprung clutch disc
Deleted vibration dampener
Z3 1.9l short shift kit
Redline MLT filled transmission
Super stiffened shifter carrier
e30 M3 4.10:1 LSD /w MZ3 output flanges

ICE:

Alpine CDM-9803 Headunit
RTC 19 - MB Quart Reference Neo Tweeter
RWC160 -6.5 MB Quart Reference Midbass Driver
JL Audio 250/1 Amp
JL Audio 300/4 Amp
JL Audio 10W3v2 subwoofer (dual 4Ω)
Completely custom made enclosure for subwoofer
Custom rear deck with aeroport exit
Custom false accent panel for amps
3 pair Acoustic Research balanced gold plated RCA's

Suspension:

H&R Cupkit
17x7.5 M-Doublespoke II (front, 225's)
17x8.5 M-Doublespoke II (rear, 245's)
Full 5-Lug conversion /w big brakes.
e46 M3 RSM's
Remanufactured steering rack
New inner & outer tie rods
Treehouse Racing "Eyeball Arms"
IE urethane sub frame mounts
IE Urethane trailing arm bushings
M-Roadster rear trailing arms
E30 M3 front strut assemblies
e30 M3 rear swaybar
M-Roadster half shafts
e36 LTW M3 X-Brace
Sparco strut bar (painted body color)

Brakes:

VHT silver, fully rebuilt calipers:
E36 M3 front calipers
M-Roadster rear calipers
25mm Brake Master Cylinder
Precision stainless steel brake lines
315x28mm front rotors (e36 M3)
SBI rotor spacers
312x20mm rear rotors (MZ3)
Custom rear brake lines

Interior:

Fully converted black leather interior (was Cardinal)
Black leather e36 M3 "Vader" front seats
Custom seat belt retention bars
Black leather M3 rear seat
Black suede headliner
M-Technic II steering wheel
ACS style pedals
e36 window switches
Leather shift boot
Leather e-brake boot
Leather e36 328iS e-brake handle
e36 gauge needle conversion
Non-locking Glove Box Handle
Custom kickpanel replacement pods
Custom 4 gauge pod (replaces center a/c vents)
VDO oil pressure, oil temperature, and voltage gauge
VDO oil temp & pressure sending units
Autometer Z series Air/Fuel gauge
Conversion to scissors style window regulators
Tinted windows, 35% fronts, 20% rears
European HVAC/Radio centered panel
BMW M-Technic door sills

Lighting:

MHW smoked front turn signals
MHW smoked tail lights
Bosch euro smiley ellipsoids
Phillips HID 4300k D2R (Low beams)
Osram Silverstar 55watt H1 x 2 (High beams)
New ZKW foglamps
Osram 55watt H3 x 2

Other:

Entire car disassembled, painted, & reassembled by hand
Every fastener cleaned and detailed prior to reassembly
Stripped, cleaned, and re-undercoated undercarriage
Deleted A/C
Deleted all sound deadening
Deleted 13 button OBC
Deleted Cruise Control
Deleted washer fluid tank, pump, and lines
Deleted 3rd brake light housing
Keyless entry /w alarm & multiple shock sensors
High strand count copper ground straps
4ga alternator primary output cabling

Future plans are always in the works!!

Right now I have 375lb F / 450lb R Ground Control coilovers, Ireland Engineering camber plates, Koni SA's and Ground Control RSM's ready to go on the car.

Next weekend I'm pulling the head off and swapping a super heavily ported/polished head on witha 5 angle valve grind, along with full length ceramic coated headers and catless midpipes.

[ian332isport]

Looking sweet Jordan

Lovin the Booty as well

Ian.

[glenn]

welcome jordan,
seen you around on dtm.net

[bootyman]

Nice looking car dude, but some bird was blocking my view so i didn't see most of it properly

[JOSEMI]

Hey !, I've seen that chick before, in Dominitry's template in the thread 'bored so...', and he said she wasn't real...

She's not real, i don't know anyone like that so i photoshoped her in, it is my car though.

hmmmmm I smell stinky fish...
Jose

[bootyman]

Jose you must have a fantastic nose. How on Earth can you smell her stinky fish from where you are?

[JOSEMI]

Jose you must have a fantastic nose. How on Earth can you smell her stinky fish from where you are?

I have super-powers...

Just found the thread (sixth picture on jordan's set);

http://www.e30zone.co.uk/modules.php?na ... ht=#241694

Jose

[bootyman]

Read the thread again Jose. He say's he found her on some American website (Car Domain), then he photshopped her onto his car. I had a look at the site and it's the same pictures that Jordan has posted up here and indeed one of the pictures is the one he has photoshopped, so i dont know what fish you can smell mate, but i suggest you go and wash your fingers

[JOSEMI]

Yep it does he found it in some american domain...
I checked my fingers, they smell of petrol !! (just filled my car)
Bootyman, are you an Dominitry related or somethin' ? I noted that he is online and was expecting him to erply ?!?

Jose

[bootyman]

Erm. Well i've got a permanant tan, so unless he originated from Africa, then I'd say NO

[H35-IAN]

now then that is a proper nice car jordan!! my god thats also a very fine young lady !! the spec m8 is amazing fair play to you wat sort of power u kicking out at the minute buddy ?? very interesting the way uve really changed things its got lovely looks m8!!

[Jordan]

Last dyno put down 170rwhp and 176rwtq.

New head/headers are going on this weekend, and after I retune the engine management I'm hoping for 185-190rwhp/tq.

Thanks for the compliments on the lady friend, glad you guys appreciate her figure!

[nav786]

. very nice and i aint started on the car yet.

the car looks mint as. the spec is just amazing. good work dude. top stuff

[Jimbob]

Nice car, I imagine we'll hear from you again when you have another photoshoot.

[bootyman]

The location for the pictures are fantastic too

[Hyperion]

very sexy car and girl, but why did you delete the lux items , like AC and cruise control??? ...weight saving?

[rare]

Very nice car, and so so much time and effort spent on it... Not a fan of the wheels at all, but the rest of it is spot on.

[tbmw]

very nice car and extremely well done m8

[Gouki]

hehe nice to see you in the E30 zone Jordan no doubt you'll recognise my car in the signature guv.

[Geeman]

I've always like this car. I think it's great. The addition of the E36 M3 rims just finish it off perfectly... I'm a big fan of these wheels...

Oh, and she's not bad too...

[smit325is]

Love the car mate, the wheels look great on it, the girl helps as well

[Demlotcrew]

Nice to see you up and about on the net again!

Andrew

[Jordan]

Made this video a couple nights ago. Its by no means exciting to watch, its more for the audio of the new exhaust. It's just nicer to watch a video while you listen!

75.8mb
4mins 48seconds.
DivX video, MP3 audio

**RIGHT CLICK SAVE AS**
http://jordan.lodac.com/Ripit.avi

[Conan]

i may be really confused here - but why is it only puting out 170-80hp with all that kit and displacment. Am i missing something?

[Jon_Bmw]

i may be really confused here - but why is it only puting out 170-80hp with all that kit and displacment. Am i missing something?

This will be at the rear wheels for sure as its an american car and they love the power at the rear wheels

[Gunni]

i may be really confused here - but why is it only puting out 170-80hp with all that kit and displacment. Am i missing something?

AT THE WHEELS not crank

[Jordan]

As Gunni said, that is wheel hp/tq. The way a Dyno measures it.

Its roughly 206hp/213tq at the crank.

Should be significantly more now with the new head/headers/exhaust, and even more after I retune the engine management.

[Jordan]

all that kit

What "kit" exactly is it that you speak of?

[DubsterNI]

hey dude, thats a well cool e30 there, love the way you've kept it all bm stuff except newer, works really well. The video was class, the note is awesome! Well done, very good car!