E30 325i sport suspension advice.

[squeal]

Just put OEM sport rear springs on my 325 sport and now feel the front is sitting too low,or infact i feel the back is a little too high.My question is this: is there an aftermarket quality spring set up that retains standard sport ride height give or take 5mm as i feel buying all 4 now is my only way to ensure i get this right.At BMW prices i would rather i got a quality aftermarket spring as i am usually disappointed in BMW springs,and even more disappointed in Euro Car parts equivalents.

Any help appreciated..

[anothere21323i]

To be honest, the only choice other than genuine BMW M Tech springs are either Eibach or H & R. Both are fantastic quality and you won't be disappointed. What dampers and anti roll bars are you using?

[squeal]

Car is totally standard and i would prefer to keep it that way appearance wise...are the eibach/hr alternatives specific lowering springs or good alternatives to oem?

[anothere21323i]

Hi there, Eibach and H&R springs will lower your car by about 30/35mm or so. They are very very high quality and your car will ride well with them, whether you fit Bilsteins or standard Boge M Tech dampers. If you want to go completely standard, then I don't think there is any quality alternative other than genuine BMW parts.

[Kedge]

You sure it's not appearing to sit high because you've been used to tired old suspension that actually sat low and is infact still sitting low on the front?

[Morat]

I think Kedge is probably right, these things look like 4x4s on new standard springs and MTech were only 15mm or so lower than stock.

[squeal]

I agree that could be the case and therefore new front springs OEM style may be the way to go...however the 4x4 look isnt that appealing either lol