fixed now
Moderator: martauto
-
LagunaE30
- E30 Zone Regular
- Posts: 635
- Joined: Mon Sep 21, 2009 11:00 pm
fixed
Last edited by LagunaE30 on Sun Nov 04, 2012 7:14 pm, edited 1 time in total.
-
maf260
- E30 Zone Regular
- Posts: 844
- Joined: Mon Oct 01, 2007 11:00 pm
You've got the same set up as me. My slave shat itself the first time I used it. I changed the slave and remember noticing how easily it fitted compared to the previous one. It's been absolutely fine since, so yours should be too.
-
rich318i
- E30 Zone Addict
- Posts: 2393
- Joined: Wed Oct 26, 2005 11:00 pm
- Location: Brands :) :)
mine did the same the rod popped out looked abit worn so got a new one after about a 3-4 weeks got a sweak as the clutch was at the floor. checked the slave and the rod had been pushed out again. had a check on the net and realOEM, there is a 5mm gap that has to be made up on the release bearing. some get away with it and some dont it seems.
the bearing they say use is a E30 323i as its got the 5mm extra for the folk on it but i just used bits from a old bearing the take up the 5mm gap. Now its fine!!!
also bought a new pivot point and spring for the folk just incase. they cost pence from bmw
the bearing they say use is a E30 323i as its got the 5mm extra for the folk on it but i just used bits from a old bearing the take up the 5mm gap. Now its fine!!!
also bought a new pivot point and spring for the folk just incase. they cost pence from bmw