I've not even had the wheels off this touring yet, so I was dreading how difficult the balljoint nuts would be to undo and how hard to separate the balljoints.
Well, the good news was that somebody had recently been in there and done the bottom arms, outer rod ends and brakes
The bad news, they were fucking monkeys who loved their air tools
First problem - they had used the airgun to force a nut that was too small onto the o/s trackrod ball joint. It came off easy enough, but once off I could see the mullered thread on the ball joint - I guess they used the old nut, not the one that came with the new trackrod.
Second problem was similar, but this time on the n/s bottom ball joint.
Third was, yet again the airgun on the caliper mount bolts.
Forth was how tight they had done up the disc retaining bolts
So, that's a replacement trackrod and bottom arm needed, and looking at the history with the car, I reckon they've done less than 4k miles
I really don't understand peoples need to massively over tighten stuff with airguns
Still, on the plus side, the balljoints pretty much fell apart and car looks so much better now its not 4x4 spec up front
Haven't decided if I'm going to do the back yet, it looks quite cool 'nose down' lol







