Hi lads
im getting tired of using the key and would like to fit remote central locking.
i dont want or need an alarm - i have an m52 conversion with ews that gives me piece of mind, i just want the ability to lock and unlock the car quicker
my question is this
how good is the standard e30 system? how common is the kit? how expensive are they?
or would i be better off going aftermarket?
for a bonus point what do you actually install? are there sensors to hide?
cheers,
Matt
remote central locking, retrofit?
Moderator: martauto
-
randomspeedfreak
- E30 Zone Regular

- Posts: 992
- Joined: Mon Mar 15, 2010 11:00 pm
- Location: Bristol
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
The standard E30 central locking is of the quality you would expect from BMW, and far superior to any after market junk out there.
I've no idea how much one of our traders would charge for a complete retrofit kit, but, given the ultra reliability of the system (assuming a bit of lubrication every twenty years or so), supply must considerably outstrip demand, so I wouldn't expect prices to be high.
The remote part of the standard system (part of the alarm) is, however, extremely primitive by today's standards, and I would recommend the excellent remote locking kit supplied by 'Rightclick'.
There's absolutely nothing 'to hide'. The normal place to fit the Rightclick module is above/behind the glovebox area, where BMW thoughtfully provide all the wires you need to connect to.
I've no idea how much one of our traders would charge for a complete retrofit kit, but, given the ultra reliability of the system (assuming a bit of lubrication every twenty years or so), supply must considerably outstrip demand, so I wouldn't expect prices to be high.
The remote part of the standard system (part of the alarm) is, however, extremely primitive by today's standards, and I would recommend the excellent remote locking kit supplied by 'Rightclick'.
There's absolutely nothing 'to hide'. The normal place to fit the Rightclick module is above/behind the glovebox area, where BMW thoughtfully provide all the wires you need to connect to.
-
randomspeedfreak
- E30 Zone Regular

- Posts: 992
- Joined: Mon Mar 15, 2010 11:00 pm
- Location: Bristol
thanks again Brian.
i do already have central locking, i am just after the remote part of the system
ive been on the rightclick website, im struggling to locate a package that just contains the remote and the module? or will i have to replace the solenoids aswell?
cheers,
Matt
i do already have central locking, i am just after the remote part of the system
ive been on the rightclick website, im struggling to locate a package that just contains the remote and the module? or will i have to replace the solenoids aswell?
cheers,
Matt
-
randomspeedfreak
- E30 Zone Regular

- Posts: 992
- Joined: Mon Mar 15, 2010 11:00 pm
- Location: Bristol
thanks again Brian.
i do already have central locking, i am just after the remote part of the system
ive been on the rightclick website, im struggling to locate a package that just contains the remote and the module? or will i have to replace the solenoids aswell?
cheers,
Matt
i do already have central locking, i am just after the remote part of the system
ive been on the rightclick website, im struggling to locate a package that just contains the remote and the module? or will i have to replace the solenoids aswell?
cheers,
Matt
-
cee
- E30 Zone Regular

- Posts: 983
- Joined: Sun Aug 23, 2009 11:00 pm
- Location: Plymouth
There are a few kits around that allow for a fob within the key rather than having the annoying large square fob seperate to the key. I have seen good ratings for these and have seen them available on ebay. Not sure what's what but may be worth a look if you prefer a neat set of keys.

1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
-
randomspeedfreak
- E30 Zone Regular

- Posts: 992
- Joined: Mon Mar 15, 2010 11:00 pm
- Location: Bristol
thanks for your idea, but the transponder chip required for the m52 ews is already inside the body of the actual key.cee wrote:There are a few kits around that allow for a fob within the key rather than having the annoying large square fob seperate to the key. I have seen good ratings for these and have seen them available on ebay. Not sure what's what but may be worth a look if you prefer a neat set of keys.
cheers though id definatley do that if it was still just the torch in there
cheers, Matt
-
cee
- E30 Zone Regular

- Posts: 983
- Joined: Sun Aug 23, 2009 11:00 pm
- Location: Plymouth
Ah I see, fair enough.

1990 Sterlingsilber 318iS - 146 bhp / 192 Nm
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
http://www.rclick.co.uk/index.php?cPath=50
Any of these will do the job, and some have key blades that can be cut to suit your ignition lock, and there might just be room inside the case for the EWS transponder chip, although I haven't tried this. They also used to list a fob with a blade, that was a copy of the diamond shaped OE E46/E39 key, and I think that these may still be available by request.
The receiver module should be fitted above/behind the glovebox, where all the wires required are available. The connection to the central locking is made to the lock and unlock request wires coming from the the passenger door A pillar socket, where the come out through the speaker hole.
Use the forum 'search' button to search for 'rightclick' and my username, and you should find detailed info. on all the connections.
Any of these will do the job, and some have key blades that can be cut to suit your ignition lock, and there might just be room inside the case for the EWS transponder chip, although I haven't tried this. They also used to list a fob with a blade, that was a copy of the diamond shaped OE E46/E39 key, and I think that these may still be available by request.
The receiver module should be fitted above/behind the glovebox, where all the wires required are available. The connection to the central locking is made to the lock and unlock request wires coming from the the passenger door A pillar socket, where the come out through the speaker hole.
Use the forum 'search' button to search for 'rightclick' and my username, and you should find detailed info. on all the connections.
