restoring
Moderator: martauto
-
mucka88
- E30 Zone Newbie

- Posts: 129
- Joined: Wed Feb 22, 2012 11:00 pm
Under my windscreen seems to have faded quite abit, with little rust holes
, so looking to tidy up, while i save and get it proply done windscreen out etc. my question is the plastic parts(vents) how do i get them off just pop off or.... thanks
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
That's a very long winded way of asking a question 
Here's your answer:
http://www.e30zone.net/e30zonewiki/inde ... vent_panel
Here's your answer:
http://www.e30zone.net/e30zonewiki/inde ... vent_panel
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
The vents DO NOT "just pry off" as it says in the wiki! Prying them off will scratch right through the paint at the bottom.
The correct way to remove the vents is to slide them straight downwards, compressing the spring clips at the bottom, until the plastic hooks at the top come clear of the metal. Then pull outwards at the top, and lift out.
To replace them, put the bottom edge in place, then push down until the clips at the top of the vent clear the metal, allowing the vent to go in flush, then ensure it slides up a couple of mm into place.
The correct way to remove the vents is to slide them straight downwards, compressing the spring clips at the bottom, until the plastic hooks at the top come clear of the metal. Then pull outwards at the top, and lift out.
To replace them, put the bottom edge in place, then push down until the clips at the top of the vent clear the metal, allowing the vent to go in flush, then ensure it slides up a couple of mm into place.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Wiki amended. Thanks for your help, Brian 
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
mucka88
- E30 Zone Newbie

- Posts: 129
- Joined: Wed Feb 22, 2012 11:00 pm
Thank you both , will be trying tomoro, get it undercoated 
