I have removed the original master cylinder & servo on the left hand side and will be fitting a floor mounted pedal box with dual m/c on the right hand side. The rear brake lines I have already replaced, but instead of running the front-rear line along the sill, I will be running it inside the car along the transmission tunnel and into the driver's footwell from behind the centre console.
As for the fronts, I want to use the original clips etc as much as possible! But my main question is this - do the left and right hand sides of the front circuit, after they have split, have to be approximately the same length?
Any other tips/suggestions are more than welcome! Thanks!
