Hi, just bought an E30 and all was well until i started poking around underneath. Turns out a load of rot had been covered up by a new paintjob so im more than miffed off at the moment.
So....looking like im going to have to weld a new section into the drivers footwell, put a new wing on it, and the bit im going to struggle with is that is needs a new offside sill putting on.
Does anyone please have any advice and pictures i can look at to get an idea of what i need to do ? I have a little workshop that i can use to weld it up but my skills probably dont stretch as far as replacing a sill. Any help please!!!
E30 in need of body repair, advice needed please
Moderator: martauto
-
pacerpete
- E30 Zone Team Member

- Posts: 18165
- Joined: Sun Jan 23, 2005 11:00 pm
- Location: Iver heath. South bucks.
Lets have some pics of the nasties, then we can advise you on a plan of action 
-
Rich320I
- E30 Zone Camper

- Posts: 1272
- Joined: Tue Dec 06, 2011 11:00 pm
- Location: Worcester
As in directions to the nearest weighbridge?pacerpete wrote:Lets have some pics of the nasties, then we can advise you on a plan of action
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
This page documents where all the common E30 rust lurks:
http://www.e30zone.net/e30zonewiki/index.php/Rust
and here's how people have fixed it:
http://www.e30zone.net/e30zonewiki/inde ... storations
(including my own, which documents floor and sill repairs).
http://www.e30zone.net/e30zonewiki/index.php/Rust
and here's how people have fixed it:
http://www.e30zone.net/e30zonewiki/inde ... storations
(including my own, which documents floor and sill repairs).
'89 325i Touring | Touring Resto Thread | In-Dash Screen install

