Another m52 miss fire
Moderator: martauto
-
jimmymig
- E30 Zone Newbie

- Posts: 135
- Joined: Thu Jul 24, 2008 11:00 pm
- Location: Swindon
This one is starting to wind me up! Car has a miss fire on idle a little pop every 3-4 sec! It is missing badly for about half a mile then clears runs really nice. But it will cut out pulling up to a stop then run badly again same if I stop the car even for seconds:-( Have checked for air leaks unpluged maf car cuts out unpluged vanos still the same any ideas? Cheers jim
-
craigieeb
- E30 Zone Addict

- Posts: 4988
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: In my man cave modifying... something
Have you checked the coil packs individually?
M50 Turbo!!!
I shall say no more 
-
E30BeemerLad
- Married to the E30 Zone

- Posts: 16806
- Joined: Mon Mar 28, 2005 11:00 pm
- Location: Norfolk
Check all the injectors are plugged in/ make sure the rail going to the top of them is all pushed down and they are all clicked in fully
-
jimmymig
- E30 Zone Newbie

- Posts: 135
- Joined: Thu Jul 24, 2008 11:00 pm
- Location: Swindon
Checked injector last week how do you check coil packs?
-
DanThe
- E30 Zone Team Member

- Posts: 28649
- Joined: Sat Sep 10, 2005 11:00 pm
- Location: Staffs
Sounds like an air leak to me, ICV working ok?
-
johnl320
- E30 Zone Addict

- Posts: 3124
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Hampshire
Is it me or does there seem to be a lot of m52s struggling at the moment?
Should of stayed 12 valve
Should of stayed 12 valve
Last edited by johnl320 on Mon Jun 11, 2012 7:18 pm, edited 1 time in total.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49359
- Joined: Mon Jan 10, 2005 11:00 pm
There's a lot out there that need to learn what a code reader is and what it's for!
-
DanThe
- E30 Zone Team Member

- Posts: 28649
- Joined: Sat Sep 10, 2005 11:00 pm
- Location: Staffs
Code readers dont tell you about the split hose or open port under the inlet manifold though Brian, plenty of those about!
-
jimmymig
- E30 Zone Newbie

- Posts: 135
- Joined: Thu Jul 24, 2008 11:00 pm
- Location: Swindon
Fault code on vanos thats why its unpluged! its sticking need to change seals:-(will coil show up on diagnostic?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49359
- Joined: Mon Jan 10, 2005 11:00 pm
They will if you know how to interpret them. I presume an air leak on the inlet bits would give a lambda sensor out of range type of code.DanThe wrote:Code readers dont tell you about the split hose or open port under the inlet manifold though Brian, plenty of those about!
