Well i need to replace my head (on car that is ) as my engine has turned into the most expensive kettle ever.
Now, i have a replacement hea which came off my old car which is perfect condition, do i need to get this skimmed or will it bo ok just to fit it?
cheers
head replacement
Moderator: martauto
-
alan325i
- E30 Zone Regular
- Posts: 369
- Joined: Mon Feb 14, 2005 11:00 pm
- Location: Yardley, Birmingham
-
keith52
- E30 Zone Camper
- Posts: 1427
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: SWANSEA
Horses for courses really, the cost of skimming and pressure checking the new (sic) head may seem a waste of money now but what cost is piece of mind as i'm sure you know the head is one of the main reasons of engine failures and if ( a big if ) the head wasn't removed correctly the head could have warped . At least you'll have a better idea of what you're putting back .I know what i would do
-
Project_E30
- E30 Zone Camper
- Posts: 1107
- Joined: Thu Jan 13, 2005 11:00 pm
Get a straight edge and that will help you judge whether its warped.
-
Templ8e30
- E30 Zone Addict
- Posts: 2801
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Ashton-under-Lyne, Lancashire
Cylinder heads only need to be skimmed if they are warped or the mating surface is damaged according to my local engine specialist.
Good idea to have it checked for cracks though.
Cheers,
Iain T
Good idea to have it checked for cracks though.
Cheers,
Iain T
2007 Mazda 6 2.0 estate
Political Correctness - A concept based on the idea that its possible to pick up a turd by the clean end !