Hey there!
I've recently mounted a BTB 6-Branch manifold with a complete scorpion exhaust system. My problem is that the fit isn't very good to say the least. When I rest the whole system in my hands without stressing it, the rear muffler and tailpipes are hanging about 10 inches below where they're suppose to be, so for MOT purposes I had to tighten it up with the mounting clamps and that has led to a lot of vibration coming through the rubber mounts and it looks shit.
My initial thought was to get someone to heat up the pipes and bend them, but I'm pretty sure that it would be near impossible doing that without hurting the flow of the pipes.
My newest idea is to simply cut the system in half somewhere and mount two flexible pipes like the following to get the right angle on the system and release some pressure
http://www.world-trades.com/photo/583/5 ... pe-785.jpg
Has anyone got any experience on this, and what are your thoughts?
Cheers guys!
Fitment of BTB+Scorpion exhaust system
Moderator: martauto
