obc code function?

Post Wed Nov 30, 2005 9:44 pm

Ok, i'm fed up using my factory immobiliser, and i know i'm going to lose the fob one of these days. In order to use the obc code function do i just need the one connector going to the relay box or should there be 2, as there are 2 connecting points. Does anyone else actually use their code function?

Post Wed Nov 30, 2005 9:45 pm

there are two connections both going to the code box

you need them both to be connectd for the imbiliser to work

i dont use mine!

Post Wed Nov 30, 2005 9:46 pm

Damn that was quick! Wonder why my loom just has the 1 plug for the relay box...

Post Wed Nov 30, 2005 9:51 pm

on mine, i left both in an the engine ran without the keys

i took one out an it was fine but the code function didnt work

so i jus took the frikin thing out lol

Post Wed Nov 30, 2005 10:06 pm

Oh well, i may just by-pass the immobiliser anyway.

Post Wed Nov 30, 2005 10:07 pm

i dnt htink iv yet to see anyone use it

andrew probably does!

Post Wed Nov 30, 2005 10:26 pm

I use mine a fair bit. Gets a bit embarassing when i forget to put the code in and just end up trying to start the car for ages.

Post Wed Nov 30, 2005 10:28 pm

agent006 wrote:I use mine a fair bit. Gets a bit embarassing when i forget to put the code in and just end up trying to start the car for ages.

Post Wed Nov 30, 2005 10:32 pm

did it at sainsburys this evening.

Try and start
realise it's coded, put the code in
try and start, but realise i need to turn the electrics off and on first
try and start again but forget i need to put the code in again after turning it off
turn it off and on, put the code in, start. go home.