1990 M40 316i - M20 325i

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

Tan91
E30 Zone Regular
E30 Zone Regular
Posts: 368
Joined: Fri Jun 20, 2008 11:00 pm
Location: West London

Post Wed May 23, 2012 6:03 pm

I've got a friend that would do this conversion for me, as the car is a M40 316i 1990 and it will possibly have a M20 325i from a 1990.

The issue is he only has the engine and a few of the ancillaries, obviously I would have to get the missing ancillaries but would I have any problems with:

Exhaust is obvious as well as a 325i coding plug
Power steering (car has power steering now)
Gearbox, Clutch / Prop-shaft / Diff (currently open 4:10 I'm sure).
Wiring (Currently a 6 button OBC)
Anything else?

Any help would be much appreciated, just asking as I'm 95% certain ill go through with it. Just preparing my self if and getting to know what I may well need so I can start collecting parts.

:cool:
bmw9818
E30 Zone Addict
E30 Zone Addict
Posts: 2561
Joined: Tue Aug 11, 2009 11:00 pm
Location: Croydon

Post Wed May 23, 2012 8:40 pm

im doing this soon, erm youd need to check pin 20 on the c101 plug? iirc its on the wiki if you check, this is one of the main issues potential fire, doubt you have any issues with power steering providing you have the pump with the m20,

you need a decent diff, 4.10 is high ratio and accelaration will be mad!

obc doesnt matter esp 6 button,

id get some new engine mounts, a new propshaft centre bearing and some gearbox mounts,

im planning to redo the sump gasket as well on the m20,

obv bits such as ecu, radiator, id fit a short shifter as well while your at it,
Tan91
E30 Zone Regular
E30 Zone Regular
Posts: 368
Joined: Fri Jun 20, 2008 11:00 pm
Location: West London

Post Wed May 23, 2012 8:59 pm

bmw9818 wrote:im doing this soon, erm youd need to check pin 20 on the c101 plug? iirc its on the wiki if you check, this is one of the main issues potential fire, doubt you have any issues with power steering providing you have the pump with the m20,

you need a decent diff, 4.10 is high ratio and accelaration will be mad!

obc doesnt matter esp 6 button,

id get some new engine mounts, a new propshaft centre bearing and some gearbox mounts,

im planning to redo the sump gasket as well on the m20,

obv bits such as ecu, radiator, id fit a short shifter as well while your at it,
Oh ye defo with you on that 100%.

I will need to source a lower ratio diff as well but ill fit that in after. Would the struts need to be changed to 51mm? as I have 45mm ones now but it has uprated suspension would make a big difference would it?