hi i have just had my headgasket done and it ran sweet as. idled lovely, didnt stall at all.
car hasnt been used since having this done and went and just had my fuel tank replaced and now it seems to cut out when down revving and is idling at around 500-600rpm but is a bit up and down.
i had a problem before with the pipe from the AFM to airbox having a split in it causing it to stall. but i have since sorted that.
any ideas if any problems could be caused from changing a fuel tank, fuel lines and fuel filter? he did take the battery off because it has had some welding done too on the sills.
325 stalling when down revving.
Moderator: martauto
-
lukec88
- E30 Zone Regular

- Posts: 286
- Joined: Mon Jun 29, 2009 11:00 pm
- Location: Northamptonshire

Diamond Schwartz black 1989 325I Sport MTech 2.
-
Barx325i
- Engaged to the E30 Zone

- Posts: 6493
- Joined: Wed Jul 26, 2006 11:00 pm
sounds like an ICV fault if you have sorted the air leak, could also be a faulty TPS or possibly the FPR which saw some debris
if I'm reading this correctly you had the fuel lines, filter and tank replaced?
if I'm reading this correctly you had the fuel lines, filter and tank replaced?
-
lukec88
- E30 Zone Regular

- Posts: 286
- Joined: Mon Jun 29, 2009 11:00 pm
- Location: Northamptonshire
yeah thats right it was running lovely just after the headgasket etc was done. since then it has had the fuel tank, fuel filter, and fuel lines replaced. it has had all the brake pipes replaced too but thats obviously not going to affect the running of the car. and it had the 2 sills welded and jacking points all re done. so he had to disconnect the battery for that. i have seen somewhere about people saying after taking the battery off to let the car run on idle for about 10minutes to let it recognise whats going on?
when i moved the car on my driveway the revs kept dropping to around 200rpm and almost cutting out but then revving it seemed to just about make it pick up again. just seems a bit weird how just changing the fuel tank etc can make it run dodgy after it was running fine before it went there and the actual engine hasnt really been touched.
when i moved the car on my driveway the revs kept dropping to around 200rpm and almost cutting out but then revving it seemed to just about make it pick up again. just seems a bit weird how just changing the fuel tank etc can make it run dodgy after it was running fine before it went there and the actual engine hasnt really been touched.

Diamond Schwartz black 1989 325I Sport MTech 2.
-
lukec88
- E30 Zone Regular

- Posts: 286
- Joined: Mon Jun 29, 2009 11:00 pm
- Location: Northamptonshire
this is what the wiki says..
Idling
Possibly the most common problem on all E30s is a rough, lumpy or stalling idle of the engine. In general, the engine should sit at 700-800 revs when warm, and over 1000 when cold. Use your ears to determine what a healthy engine sounds like.
An engine will only work properly if it is in good condition. Changing both the fuel filter and air filter are a matter of course, as well as ensuring everything is plugged in correctly.
The first cause of idle problems, especially a high idle, is likely to lie with the fuelling of the car, especially controlled by the blue plug.
If you have eliminated all fuel issues, then start looking around the intake system for air leaks.
The ICV will be the next item to check. Over time it can get sticky, so simply remove it and clean it out with Carb Cleaner. It is very rare that an ICV needs to be replaced.
Once you have removed these possibilities, start looking at the TPS, which is a very common problem on the E30. A gummed-up or broken TPS will not tell the ECU that the car should be idling, and therefore the wrong fuel and air mixture will be sent to the engine.
Idling
Possibly the most common problem on all E30s is a rough, lumpy or stalling idle of the engine. In general, the engine should sit at 700-800 revs when warm, and over 1000 when cold. Use your ears to determine what a healthy engine sounds like.
An engine will only work properly if it is in good condition. Changing both the fuel filter and air filter are a matter of course, as well as ensuring everything is plugged in correctly.
The first cause of idle problems, especially a high idle, is likely to lie with the fuelling of the car, especially controlled by the blue plug.
If you have eliminated all fuel issues, then start looking around the intake system for air leaks.
The ICV will be the next item to check. Over time it can get sticky, so simply remove it and clean it out with Carb Cleaner. It is very rare that an ICV needs to be replaced.
Once you have removed these possibilities, start looking at the TPS, which is a very common problem on the E30. A gummed-up or broken TPS will not tell the ECU that the car should be idling, and therefore the wrong fuel and air mixture will be sent to the engine.

Diamond Schwartz black 1989 325I Sport MTech 2.
-
Barx325i
- Engaged to the E30 Zone

- Posts: 6493
- Joined: Wed Jul 26, 2006 11:00 pm
it's all good wholesome info,
the 10 minute rule isn't accurate per say, the ECU will retrain so drive it normally, aka belt it up the road.
tps gives resistance signals to the ECU, so can be tested with a meter, but any testing you do should really be done at the ECU plug end, thus eliminating any wiring continuity issues.
Fixing one thing can sometimes unearth another issue.
is it a lazy spluttering stall or does it die a sudden death?
the 10 minute rule isn't accurate per say, the ECU will retrain so drive it normally, aka belt it up the road.
tps gives resistance signals to the ECU, so can be tested with a meter, but any testing you do should really be done at the ECU plug end, thus eliminating any wiring continuity issues.
Fixing one thing can sometimes unearth another issue.
is it a lazy spluttering stall or does it die a sudden death?
-
lukec88
- E30 Zone Regular

- Posts: 286
- Joined: Mon Jun 29, 2009 11:00 pm
- Location: Northamptonshire
Was being pretty lazy like I say it kept going down to around 200rpm then I had to rev it to get it back up.. But if I sat still and just revved it to 4k etc then let my foot completely off the throttle it'll down rev then just stall once it gets to idle speed

Diamond Schwartz black 1989 325I Sport MTech 2.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
That sounds almost exactly like a non-functioning TPS
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
lukec88
- E30 Zone Regular

- Posts: 286
- Joined: Mon Jun 29, 2009 11:00 pm
- Location: Northamptonshire
Also when idling if I leave my foot off the accelerator completely its a bit rubbish but as soon as I put the accelerator in just a few mm it settles it nicely.

Diamond Schwartz black 1989 325I Sport MTech 2.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Pop the bonnet, identify the throttle arm and gently pull it; you should hear a faint "clicking" noise. If you don't, it's usually a sign that something's not right.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
jimmypee
- E30 Zone Newbie

- Posts: 36
- Joined: Sun Apr 17, 2011 11:00 pm
I just did my timing belt and disconnected the battery. It was idling funny after that but I drove it for a but and now it's fine
