hi to all , now in a position of fitting the cam belt on my 2.8 stroker ,but have a tech question to ask .....
with the crank on the T.D.C mark and the cam pulley lined up to the indentation mark on the end of the head can any one confirm that this will not be correct or 180degrees out ?!? iv put on and tensioner and the belt and it turns over by hand ok but just need to be sure before i progress further and find out that its not right
Rebuild /fitting of timing belt
Moderator: martauto
-
JAFF
- E30 Zone Regular
- Posts: 451
- Joined: Sun Jul 30, 2006 11:00 pm
- Location: malmesbury ,wiltshire
-
kam-325i
- E30 Zone Team Member
- Posts: 4851
- Joined: Tue Sep 27, 2005 11:00 pm
- Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!
top timing mark
Bottom timing mark
line up as shown.
Bottom timing mark
line up as shown.
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
-
JAFF
- E30 Zone Regular
- Posts: 451
- Joined: Sun Jul 30, 2006 11:00 pm
- Location: malmesbury ,wiltshire
thank you that is what iv done so you confident that it will be ok to run up ?
-
kam-325i
- E30 Zone Team Member
- Posts: 4851
- Joined: Tue Sep 27, 2005 11:00 pm
- Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!
i hope so, thats the way ive done mine, twice !!!
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
-
JAFF
- E30 Zone Regular
- Posts: 451
- Joined: Sun Jul 30, 2006 11:00 pm
- Location: malmesbury ,wiltshire
Lol well that's the way I'll do mine too 
-
Grrrmachine
- E30 Zone Wiki / Team Member
- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
'89 325i Touring | Touring Resto Thread | In-Dash Screen install