Water leak

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

lion_yo
E30 Zone Regular
E30 Zone Regular
Posts: 366
Joined: Fri Sep 04, 2009 11:00 pm
Location: Midlands, United Kingdom

Post Fri Apr 20, 2012 10:56 pm

Hi,

I have noticed water sits in the engine bay where the battery tray is I wiped it down with a cloth it rained again and checked again to find that water is collecting their again. What could be causing this?

Also I got a bottle of water and poored it down the sunroof drains.
Water came out on the passanger side so what does this mean blocked sunroof drains/do I have a loose connection somewhere?
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Fri Apr 20, 2012 11:01 pm

if you remove the seal around the bulkhead you might find some krust on the lip around that area ?
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
lion_yo
E30 Zone Regular
E30 Zone Regular
Posts: 366
Joined: Fri Sep 04, 2009 11:00 pm
Location: Midlands, United Kingdom

Post Fri Apr 20, 2012 11:31 pm

magpie wrote:if you remove the seal around the bulkhead you might find some krust on the lip around that area ?
Removed the seal and their is no rust whatsoever.
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Fri Apr 20, 2012 11:36 pm

hmm...in my knowledge if parked down hill the bonnet run offs remain clear of water,and guess what...you get puddles in the boot shuts below each corner of the rear screen .

level ground ftw :idea:
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)
Jim320i
E30 Zone News / COTM Team
E30 Zone News / COTM Team
Posts: 10627
Joined: Sun Oct 25, 2009 11:00 pm
Location: Leicestershire

Post Fri Apr 20, 2012 11:39 pm

I have exactly the same fault with mine at the moment. Although I can see where mine is getting in... Where the wing lip meets the shell lip that the rubber sits in, there was a slight gap and it was dripping through there.

Also check your alignment of your bonnet as it may be sitting slightly too high so it doesnt create a tight seal once closed?
lion_yo
E30 Zone Regular
E30 Zone Regular
Posts: 366
Joined: Fri Sep 04, 2009 11:00 pm
Location: Midlands, United Kingdom

Post Fri Apr 20, 2012 11:44 pm

Jim320i wrote:I have exactly the same fault with mine at the moment. Although I can see where mine is getting in... Where the wing lip meets the shell lip that the rubber sits in, there was a slight gap and it was dripping through there.

Also check your alignment of your bonnet as it may be sitting slightly too high so it doesnt create a tight seal once closed?
Have you resolved the problem?

Could it be that part number 9 (51 71 1 933 209)
is missing

http://bmwfans.info/parts/catalog/E30/2 ... nel_front/

Or I'm thinking the seal that goes around the bulkhead is no good?

Car is parked on a flat surface by the way.
Last edited by lion_yo on Sat Apr 21, 2012 12:35 am, edited 1 time in total.
magpie
Old Skooler
Old Skooler
Posts: 28035
Joined: Sun Jun 29, 2008 11:00 pm
Location: Consett,Durham.

Post Fri Apr 20, 2012 11:53 pm

hard to create good drainage with the aerodynamics of a concrete block.

these things need shelter .
Image
m52 b30 stroker 6-speed 318is Galvanizer
m42 touring
+ a yard full of scrap turds :)