heaters ?

[BATTS91]

me again lol , my heaters dont blow out hot on my m50 conversion ive checked the pipes there correct , from head to bottom of matrix ,
so the only rhing i can think of is heater control valve not opening , this has been recently changed for a 2nd hand unit from a zoner as mine cracked , is there some basic electrics i can check to make sure its openin and how ??? thanks

[BATTS91]

wiki to the rescue just read it shall try tomoz , that might make grrr abit happy !!!

[Grrrmachine]

[BATTS91]

i see your putting alot of time into the wiki , thus the sigh from you i see earlier lol

[Grrrmachine]

Nah, it's not my time that bothers me, it's just the attitude of "quick, post a question" rather than "quick, search for an answer."

I know the forum search is daunting, and I know the Wiki needs more tweaking so make it user-friendly, but when there's a question about Lights and there's a big box on the front page of the Wiki called Lights, I can normally tell someone's being a teeny bit lazy.

Let me know how you get on with the Heater bit, and I'll clean up the Heater page if it's confusing.

[BATTS91]

wiki is clear as bells for my problem, i think its just a case of people forgetting theres a wiki to use (edit, including me !!) ,fookin handy tho good job on the hard work
, i unplugged the thermostat n took it for a drive to get hot, but no heat so i now assume the 2nd hand stat i bought is fooked aswell ,better than having a wet carpet like the last one i spose :/

[Brianmoooore]

, i unplugged the thermostat n took it for a drive to get hot, but no heat so i now assume the 2nd hand stat i bought is fooked aswell ,better than having a wet carpet like the last one i spose :/

?? How did you 'unplug' the thermostat?

[BATTS91]

heater matrix thermostat has a 2 pin plug on top of it

[BATTS91]

or you could also call it ,heater control valve

[Brianmoooore]

You can only call it a heater control valve - it's not a thermostat of any description.
The default position of the valve is open when disconnected, and I doubt if this is your problem.
If you're sure the pipes are the right way around, I suspect you have a partial airlock (remove top heater hose to release), the matrix is partially blocked, or the cable from the heat control to the heater box has a problem, and isn't moving the blender flap to full hot.