Need info from 4 pot wrongness to 6 pot rightness please

[jonbuoy]

I am going to rip the M40 lump out and chuck in an M20 lump.

Can someone who has done this conversion before please tell me if i need to rip out the old loom or can i join at the plug??

Cheer's in advance

Jon

[Martinaston]

The motronic C101 plug is interchangable but you still have to thread the ecu part through the bulkhead.

[andyp]

well done, you have seen the light at the end of the tunnel

[jonbuoy]

The motronic C101 plug is interchangable but you still have to thread the ecu part through the bulkhead.

Thank's for your reply mate.
So basically it is the hole loom then?
Would you have more info on this at all geese?

well done, you have seen the light at the end of the tunnel

Alway's saw the light at the end of the tunnel mate, just had the wrong engine

[Demlotcrew]

You need to make sure the New engine has the engine loom attached with no cut wires, its mostly plug and pray with these moves.

Andrew