Whilst dismantling my car I have noticed that at some point in the past Stevie Wonder has had a real go at the wiring in my boot. I think he likes scotch blocks!!
Whats the best way to replace the wiring to the rear tail lights? The damage is on the main loom that runs into the boot and goes to the rear tails, boot lock etc. Can I just unplug this from the main loom somewhere at the front of the vehicle or do i have to cut it out and re-wire a new rear section in with a connector plug or something.
Any suggestions? Not really keen on replacing the whole loom tbh.
Replacing tail lights boot loom?
Moderator: martauto
-
hammoj28
- E30 Zone Addict

- Posts: 3310
- Joined: Tue Jan 25, 2005 11:00 pm
- Location: Aberdeenshire.

24v tech2
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Sorry, but it's part of the main loom, which goes all the way down the left side of the car, right around the front, and ends at the washer bottle.
My physic powers have failed me, so I don't know if your car has four pot or six pot wiring, but if it's six pot, more than half of the wires do end at the lamp check module on the left side of the boot, so if you spliced a new section from here, there'd only be a few wires to join.
My physic powers have failed me, so I don't know if your car has four pot or six pot wiring, but if it's six pot, more than half of the wires do end at the lamp check module on the left side of the boot, so if you spliced a new section from here, there'd only be a few wires to join.
-
hammoj28
- E30 Zone Addict

- Posts: 3310
- Joined: Tue Jan 25, 2005 11:00 pm
- Location: Aberdeenshire.
Thanks for the reply Brian, It's a 4 pot loom sorry. From looking at the loom I think i'm best splicing in a new bit to the bulk of the wires that run through into the boot.

24v tech2
