Hi there,
Is it easy or difficult to fit chrome bumpers on a facelift car? Car in question is a cabrio on a G plate. My assumption is that I need the bumpers off a pre facelift cabrio, however is this a straight forward mod or likely to be difficult to do?
I looked through the FAQs and searched previous posts but didn't turn anything up. Any guidance or experience of doing this would be greatly appreciated.
Thanks
MarkS100
Chrome bumpers - fit on facelift car
Moderator: martauto
-
kman82
- E30 Zone Regular

- Posts: 967
- Joined: Mon Sep 22, 2008 11:00 pm
- Location: Oxford
Swap the front valance over, that shoul dbe easy enough.
The back end is a whole new storey though, its totally different mate and will require some serious mods
The back end is a whole new storey though, its totally different mate and will require some serious mods
-
kman82
- E30 Zone Regular

- Posts: 967
- Joined: Mon Sep 22, 2008 11:00 pm
- Location: Oxford
These are the best pictures I could find. The first problem you will have is fixing the bumper on, The brackets are totally different and in a different place. Then with the chrome bumpers the shell of the car is visable below and is much smaller on the pre facelift.
Unless you fancy welding on a new rear end and back quarers I'd forget it mate
Facelift

Prefacelift

Unless you fancy welding on a new rear end and back quarers I'd forget it mate
Facelift

Prefacelift

-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland
I thought facelift cabs didn't come round to quite a bit after a G plate.
-
MarkS100
- E30 Zone Newbie

- Posts: 21
- Joined: Mon Oct 10, 2011 11:00 pm
Thanks for the responses folks. Looks like this will be a lot more involved than I imagined
Hmm, maybe those bumbers I bought will need to back in the for sale section, but I'll do some measuring and experimentation first!
-
MarkS100
- E30 Zone Newbie

- Posts: 21
- Joined: Mon Oct 10, 2011 11:00 pm
But I am also a bit confused. The car is an '89, so should be a pre-facelift. However it has colour coded bumpers not chrome. Am I muddling up pre-facelift vs. colour coded vs. facelift. Was the colour coding an interim change before BMW went to facelift on the cabrios? Any help would be great!!
-
kman82
- E30 Zone Regular

- Posts: 967
- Joined: Mon Sep 22, 2008 11:00 pm
- Location: Oxford
Convertibles are a bit weird, mines an F and the engine is facelift but shell prefacelift.
The obvious things to look for are the shape of the rear lights, number plate surround and the lower valance.
If you're lucky you may have a pre facelift shell with colour coded metal bumpers - mine had been sprayed colour coded by a previous owner.
Put some pictures up and well be able to tell you
The obvious things to look for are the shape of the rear lights, number plate surround and the lower valance.
If you're lucky you may have a pre facelift shell with colour coded metal bumpers - mine had been sprayed colour coded by a previous owner.
Put some pictures up and well be able to tell you
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
I know it's the opposite to what you want to do, but the photos here will explain the level of complexity involved:
http://www.e30zone.net/e30zonewiki/inde ... a_facelift
http://www.e30zone.net/e30zonewiki/inde ... a_facelift
87 was the facelift year, with 88 models "using up" all of the leftover components, so you get convertibles with chrome trim and facelift engine management. 89 should definitely be facelift.MarkS100 wrote:But I am also a bit confused. The car is an '89, so should be a pre-facelift.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
MarkS100
- E30 Zone Newbie

- Posts: 21
- Joined: Mon Oct 10, 2011 11:00 pm
Thanks again all. I just took a look at the back of the car and it looks much more like the prefacelift example above. I also found this piece when I was looking earlier (from an American site by the looks of the language), although no guarantees they are correct of course!
"In 1991 the 316i touring came available. This was also the year that the convertible received the same facelift as the sedan had in 1987. There was also a 318i convertible introduced. "
So I'll need to get it out of the garage and take a better look, but I am beginning to think the colour coding was confusing me and that the car does have a pre-facelift shell. I'll see if I can get some photos some time.
"In 1991 the 316i touring came available. This was also the year that the convertible received the same facelift as the sedan had in 1987. There was also a 318i convertible introduced. "
So I'll need to get it out of the garage and take a better look, but I am beginning to think the colour coding was confusing me and that the car does have a pre-facelift shell. I'll see if I can get some photos some time.
-
Topblag
- Old Skooler

- Posts: 7095
- Joined: Wed Jul 30, 2008 11:00 pm
- Location: Fife - You got a problem with that ?
I've got a g plate cab, registered Jan 1990. Comes with painted metal bumpers to match the colour of the car. Underneath they are pristine chrome but not sure if that's from the factory or after it was born.
1990 325i Cab auto in Alpine White II
1988 Alpina C2.5 moredoor in Black, 71k
1990 325ix, moredoor auto in Laser Blue. 51k
1984 Hartge H35 in Black
2004 996 C4S in Silver 43k manual
2006 Audi S6 V10 in Black 58k
1988 Alpina C2.5 moredoor in Black, 71k
1990 325ix, moredoor auto in Laser Blue. 51k
1984 Hartge H35 in Black
2004 996 C4S in Silver 43k manual
2006 Audi S6 V10 in Black 58k
-
chh137
- E30 Zone Squatter

- Posts: 1502
- Joined: Mon Apr 18, 2011 11:00 pm
- Location: deepest darkest derbyshire
My G plate 89 preface lift cab has de-chrome/colour coded from factory, as stated on original build sheet.
Get a build sheet from your dealer , just need last 7 digits of chassis no.
Get a build sheet from your dealer , just need last 7 digits of chassis no.
