Hello
I think i need to change the thermostat on my m42 as it's only getting to 1/4 temperature on the gauge.
Can i use the thermostat out of my m40 and put it into the m42?
Are they the same?
Thank you.
318is thermostat
Moderator: martauto
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
From the wiki:
http://www.e30zone.net/e30zonewiki/inde ... Temp_Gauge
"In practice, E30's have the needle just past the 1/4 mark, or almost exactly on the centre mark, depending, presumably, on the thermostat fitted. "
http://www.e30zone.net/e30zonewiki/inde ... Temp_Gauge
"In practice, E30's have the needle just past the 1/4 mark, or almost exactly on the centre mark, depending, presumably, on the thermostat fitted. "
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
Thank you, so it's possible i could have a thermostat of a lower temperature fitted?
So would it be possible to use the one from my m40 on the m42?
So would it be possible to use the one from my m40 on the m42?
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
I don't know which thermostats fit which engine (I've not written those Wiki articles yet), but why do you want to change the thermostat?
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Both the M40 and the M42 should have the same 88 degree thermostat, which normally equates to the centre of the gauge.
M20 engines use an 80 degree 'stat.
M20 engines use an 80 degree 'stat.
-
DHFiS
- Old Skooler

- Posts: 2733
- Joined: Sat Aug 12, 2006 11:00 pm
- Location: cambridge
RealOEM shows the same part number for the 318i and 318iS
http://www.realoem.com/bmw/partxref.do? ... series=E30
http://www.realoem.com/bmw/partxref.do? ... series=E30
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
ThanksBrianmoooore wrote:Both the M40 and the M42 should have the same 88 degree thermostat, which normally equates to the centre of the gauge.
M20 engines use an 80 degree 'stat.
Mine sits at 1/4, I reckon it could have a broken or incorrect thermostat in it.
Thanks
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
The reason I posted the Wiki link was so that you could read this:
"The E30 temperature gauge is not linear - it's compressed at each end, with the whole centre section, from just clear of the blue to just before the red, covering just a few degrees. The needle anywhere is this whole section is fine, according to BMW. "
Nothing's wrong with your car
"The E30 temperature gauge is not linear - it's compressed at each end, with the whole centre section, from just clear of the blue to just before the red, covering just a few degrees. The needle anywhere is this whole section is fine, according to BMW. "
Nothing's wrong with your car
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Genuine BMW thermostats have a habit of breaking at one side of the bridge piece that holds the fixed end of the wax capsule, which tends to mess up the calibration a little, so it could be that, or, as you say, the wrong one might be in there.
TBH, as long as it holds the running temperature constant, and below three quarters, there's not too much to worry about.
TBH, as long as it holds the running temperature constant, and below three quarters, there's not too much to worry about.
-
redcar
- E30 Zone Squatter

- Posts: 1610
- Joined: Wed Jul 20, 2011 11:00 pm
- Location: Hertfordshire
Thanks for the infoBrianmoooore wrote:Genuine BMW thermostats have a habit of breaking at one side of the bridge piece that holds the fixed end of the wax capsule, which tends to mess up the calibration a little, so it could be that, or, as you say, the wrong one might be in there.
TBH, as long as it holds the running temperature constant, and below three quarters, there's not too much to worry about.
Was worried because the old m40 used to go to half and pretty quickly
I'll swap the thermostats over and see if it makes a difference, but as you said...it probably isn't much of an issue as it stays at 1/4
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Operating temp. of the 'stat will be stamped on it somewhere.
