How to change HT lead nº4 / Cylinder identifier sensor

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
DaniTD
E30 Zone Newbie
E30 Zone Newbie
Posts: 196
Joined: Wed Oct 07, 2009 11:00 pm

Post Sun Jan 22, 2012 12:06 am

Hi!
After making some tweakings to my M40 seems like the cylinder identification sensor has broken. Because the HT leads are reasonably well for their age, I got a second hand nº4 HT lead with the CID sensor.
I want to know if it's necessary to dissasemble anything to put out the old and put in the new cable and how to do it, because it goes in front of the timing belt cover to the diagnostic socket. I understand how to change the other 3 HT leads, it's pretty easy, but this one seems to be tricky.

Can this make the engine run smoother on cold? Because it seems to flood on cold, even one day I started it like 10 seconds to test a thing, and when next day I was going to start it it was like some sparkplug was flooded, it was running on 3 cylinder :(

Thanks!
Rtaylor2208
E30 Zone Addict
E30 Zone Addict
Posts: 3004
Joined: Mon Oct 11, 2010 11:00 pm
Location: Ayr, Ayrshire, Scotland

Post Sun Jan 22, 2012 2:24 pm

Not sure on a M40 but on the m20 I had to remove the distributor cap to make enough room to get the lead with the sensor a cross the front of the engine between the fan and radiator.
Rtaylor2208
E30 Zone Addict
E30 Zone Addict
Posts: 3004
Joined: Mon Oct 11, 2010 11:00 pm
Location: Ayr, Ayrshire, Scotland

Post Sun Jan 22, 2012 2:24 pm

Not sure on a M40 but on the m20 I had to remove the distributor cap to make enough room to get the lead with the sensor a cross the front of the engine between the fan and radiator.
User avatar
DaniTD
E30 Zone Newbie
E30 Zone Newbie
Posts: 196
Joined: Wed Oct 07, 2009 11:00 pm

Post Sun Jan 22, 2012 2:36 pm

As I can see, on the M40 the snors goes from the distributor, down infront of the timing belt cover with the CPS cable and then under the intake manifold, the it reachs the diagnostic socket connector. See if anyone knows if it can be changed without dismantling anything :?
User avatar
DaniTD
E30 Zone Newbie
E30 Zone Newbie
Posts: 196
Joined: Wed Oct 07, 2009 11:00 pm

Post Sun Jan 22, 2012 9:27 pm

Bump
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Jan 22, 2012 9:44 pm

Difficult to route it properly with the bits on the front of the engine in place, so I'd just route it over the top of the engine until something like a cam belt change is done.
The engine does run 'better' with the sensor connected, but nothing that you'd notice in anything other than a back to back test.
Whatever fault you're trying to cure, this won't be the answer, I'm afraid.