Hi.
I'm having issues with my new suspension (its sits too close to the wheels to be able to lower it)
To be able to try and resolve it, I need to find out the offset of my wheels. I've looked up on the internet but cant seem to find anything. On the wheel I can see the width etc, but don't seem to be able to find the offset. Is it stamped on them, or is there a standard size for them?
I have 16" Genuine Alpinas.
The tyres are 205/50 which seems to be the size others have used, so I didn't think they would cause a problem.
Thanks
How to find wheel offset
Moderator: martauto
-
randomspeedfreak
- E30 Zone Regular

- Posts: 992
- Joined: Mon Mar 15, 2010 11:00 pm
- Location: Bristol
the et is the offset of the hub mounting face relative to the centerline of the wheel. so for example if you have an 8J wheel, you would measure 4 inches towards the mounting face from the back of the rim, the distance from this point to the mounting face is the offset (in mm)LilJen wrote:Hi.
I'm having issues with my new suspension (its sits too close to the wheels to be able to lower it)
To be able to try and resolve it, I need to find out the offset of my wheels. I've looked up on the internet but cant seem to find anything. On the wheel I can see the width etc, but don't seem to be able to find the offset. Is it stamped on them, or is there a standard size for them?
I have 16" Genuine Alpinas.
The tyres are 205/50 which seems to be the size others have used, so I didn't think they would cause a problem.
Thanks
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
What suspension have you had fitted???
Alpina 7j wheels are ET 28 iirc.
These should fit with no issues at all on E30's.
Alpina 7j wheels are ET 28 iirc.
These should fit with no issues at all on E30's.

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
LilJen
- E30 Zone Newbie

- Posts: 130
- Joined: Fri Oct 16, 2009 11:00 pm
- Location: Anglesey, N.Wales
Ive had a Gaz GHA coilover kit fitted. Its all on ok, and rear is set up nicely, but if I drop the front anymore it will rub the tyre.
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
On the Gaz coilovers you need to run a shorter spring, and not the ones supplied with them.
There has been a few issues on here already with their coilovers and this seems to be the main issue with the longer springs supplied.
There has been a few issues on here already with their coilovers and this seems to be the main issue with the longer springs supplied.

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
LilJen
- E30 Zone Newbie

- Posts: 130
- Joined: Fri Oct 16, 2009 11:00 pm
- Location: Anglesey, N.Wales
I've gone through a very reputable company to get them, but they never mentioned anything about springs, unless the wires have crossed somewhere, and manufacturers sent out the wrong ones.
-
Jhonno
- Homo Hair
- Posts: 20362
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: FLAT, FLAT, FLAT!!
With coilovers you tend to need to run a spacer or lower offset wheels. End of. A shorter spring is a bit of a bodge and will reduce bump travel available.
It's due to the spring seat position being changed.
It's due to the spring seat position being changed.
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
That's what the problem is Dan, the seat for the spring being low and catching..
As Dan said, it's either spacers or as I said, a shorter spring.
As Dan said, it's either spacers or as I said, a shorter spring.

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
-
LilJen
- E30 Zone Newbie

- Posts: 130
- Joined: Fri Oct 16, 2009 11:00 pm
- Location: Anglesey, N.Wales
What sort of size spacers can you get away with before it starts causing any issues? I will try them 1st and then if that doesn't work, I will have to get shorter springs 
-
Rav335uk
- E30 Zone Meets/Events Team

- Posts: 27978
- Joined: Wed Jan 19, 2005 11:00 pm
- Location: Mad mad mad
I think the majority who run them are between 5-10mm. I think you should be fine with 5mm

If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL

