Have not been on the site for a while, but yesterday decided to give my 325 convertible a run out, as the weather was warm and dry.
Car has been dry stored for several months but started first time and all the electrics were tested and ran OK.
However, previously the fan heater motor always made a bit of a squeeling noise on number 2 setting and sometimes did not work on the number 2 setting (suspected resistor problems).
However yesterday as part of my testing, when I turned the heater fan switch on, the fan made a very load sqeeling noise and as I switched from 1 to 4 the noise continued and then stopped.
As a result the fan is no longer operational.
My question is how easy is it to remove the fan motor as I suspect the bearings are either knackered or dry which might have caused an unnecessary overload and blown a fuse, and secondly, as I was already experiencing an intermitant fault on the fan switch, how easy is it to remove switch and the resistor which I think controls the fan speed, which I think has probably burnt out.
I will check the fuse position this weekend when I return from work.
Just thought I would prepare myself for every eventuality.
By the away the car has air conditioning, so I m not sure if the fan motor assembly is similar to a none air con car.
Have just spent a few minutes looking at past posts along similar lines to this one.
Looks to me as though the resistor pack has burnt out and the bearings on my fan need a recon.
Question is now, where is the resistor pack situated on a '91 J reg 325 convertible with air con. or do I need to replace the fan speed switch (61311381201) ?
Secondly how easy is it to remove the heater fans and motor from the bulkhead ?
Any advice or pics. would be most appreciated
Heater switch and fan problem
Moderator: martauto
-
Rtaylor2208
- E30 Zone Addict

- Posts: 3004
- Joined: Mon Oct 11, 2010 11:00 pm
- Location: Ayr, Ayrshire, Scotland

