fitting seal to my lsd
Moderator: martauto
-
321gazza
- E30 Zone Regular

- Posts: 342
- Joined: Fri Sep 07, 2007 11:00 pm
have purchased an lsd diff from a tech1 325i, want to fit new oil seals to the drive shaft end of the diff, is it simply a case of pulling out the seals and pushing the new one in and also is it the same with the front seal with the metal cover were the prop bolts onto, pineon oil seal i think its named.
-
Supafly
- E30 Zone Regular

- Posts: 559
- Joined: Wed Feb 22, 2006 11:00 pm
The output shaft seals are easy enough, check the lsd rebuild threads and it's all pictured. It was a long while ago when I changed mine, the output shafts just pop out, you might need to unbolt the caps to get at the seals....
As for the input seal, don't touch it unless you need to, from my reading on the subject it will need some careful setting up afterwards to maintain the pinion settings.
As for the input seal, don't touch it unless you need to, from my reading on the subject it will need some careful setting up afterwards to maintain the pinion settings.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
As above - output seals easy; input seal - don't touch unless you know exactly what you're doing.
-
321gazza
- E30 Zone Regular

- Posts: 342
- Joined: Fri Sep 07, 2007 11:00 pm
Ok many thanks, nothing to reset if i take output shaft caps off to replace the seals.
-
Supafly
- E30 Zone Regular

- Posts: 559
- Joined: Wed Feb 22, 2006 11:00 pm
No, easy peasy. Just make sure everything goes back together in the same order.
