cluster lights
Moderator: martauto
-
E30Gheko
- E30 Zone Addict

- Posts: 3789
- Joined: Sun Sep 28, 2008 11:00 pm
- Location: Wirral
half my cluster lights work fine but the half that does the rev counter and temp guage work intermitently. loose connection somewhere but where do i start looking??
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Change the bulb. It probably has a broken filament, where occasionally the two ends touch and stick.
-
E30Gheko
- E30 Zone Addict

- Posts: 3789
- Joined: Sun Sep 28, 2008 11:00 pm
- Location: Wirral
OK sounds like a plan Brian. I'm fine about taking the cluster out, but once removed is it easy to see where the bulb is?
-
Sanchez
- Married to the E30 Zone

- Posts: 7578
- Joined: Sun Apr 17, 2005 11:00 pm
- Location: Sunny Scotland
Yep. When you undo the screws from the back, separate it and you'll see 2 big orange bulbs.
i think the orange is just a cover IIRC.
i think the orange is just a cover IIRC.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
You don't need to dismantle the cluster to change the bulbs!
The two for the illumination are similar to all the warning lamps, but are considerably bigger.
It's just about possible to change them by reaching up from underneath without removing the cluster, especially if you devise a tool or two to help.
If you do remove it, tighten the two small brass nuts on the back, and if you go as far as to open it up, check SI board has NiCd batteries. If it has, put the board in the freezer for ten minutes, and measure the voltage on the batteries.
The two for the illumination are similar to all the warning lamps, but are considerably bigger.
It's just about possible to change them by reaching up from underneath without removing the cluster, especially if you devise a tool or two to help.
If you do remove it, tighten the two small brass nuts on the back, and if you go as far as to open it up, check SI board has NiCd batteries. If it has, put the board in the freezer for ten minutes, and measure the voltage on the batteries.
-
SGP
- E30 Zone Regular

- Posts: 502
- Joined: Thu Aug 31, 2006 11:00 pm
Hi. Brian, what minimum voltage should good batteries return ? I have a couple and want to use the best one in my restoration. Thanks.
If it ain't broke..
Fix it till it is
Fix it till it is
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
There should be at least 1.2 volts across each battery. Any less, or if they show any signs of leaking, then change them.
For a restoration, they should be probably be changed anyway.
For a restoration, they should be probably be changed anyway.
