icv
Moderator: martauto
-
pcs
- E30 Zone Newbie

- Posts: 17
- Joined: Wed Jul 13, 2011 11:00 pm
- Location: Timaru, New Zealand
Hi..trouble shooting on my 325. According to my Haines manual, when I disconnect the ICV, the idle should change to 2000 rpm. Have tried 2 icv's and neither give any change at all to idle rpm when disconnected. Wondering why no change and what may be going on.........?
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Haynes is a load of bollocks. The Bentley manual is much better, if you know where to find it online. Unplugging the ICV won't change much at all.
What are the problems with your car?
What are the problems with your car?
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
The three wire ICV just stays put when it's disconnected, so absolutely nothing should happen in the short term, unless the load on the engine changes.
What problem are you trying to solve, and what version of the 325 management do you have? I see you're in the antipodes, and some of you appear to have some of the ancient E30s still running.
What problem are you trying to solve, and what version of the 325 management do you have? I see you're in the antipodes, and some of you appear to have some of the ancient E30s still running.
-
pcs
- E30 Zone Newbie

- Posts: 17
- Joined: Wed Jul 13, 2011 11:00 pm
- Location: Timaru, New Zealand
Thanks for the replies. This is a 1990 325. NZ version comes with no oxygen sensor or cat converter. The car runs well until 90kph, then starts to "miss" a bit for want of a better term. By 100kph it's quite pronounced, starts to smooth out by 115kph and is running beautifully at 120kph or 2700rpm. Have been told (by BMW here) this could be "lean stumbling", and was a fairly common problem on NZ new 325s. It used to be remedied by BMW changing the ECU from Cat Prep, to Cat Version, which told the ECU the O2 sensor and cat converter had been fitted. The ECU, unable to find both, then runs the car on an emergency programme and enriches the mixture and no more missing, stumbling in this narrow speed/rpm band.......it seems my nearest BMW service centre can no longer do the programme change on the ECU. So I am trying to find another fix to this very irritating drivability issue. Suggestions will be most gratefully received. Thanks very much.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
If this symptom has just occured, then it's more likely a degrading component than a factory flaw, which is what the ECU "fix" you're referring to is.
For starters, the moment you press the accelerator pedal the ICV should be out of the system; it's the Idle Control Valve, so if the engine isn't at idle, then it's not part of the problem.
What you ought to look for is whether this symptom occurs at a specific rev range; rather than speed, does it feel like the engine is bogging down around 2000 revs in all gears, or is it only at the speeds you mentioned?
The typical fault for low power is overfuelling; this is either dribbly injectors, or the Blue Temp Sensor:
http://www.e30zone.net/e30zonewiki/index.php/Blue_Plug
For starters, the moment you press the accelerator pedal the ICV should be out of the system; it's the Idle Control Valve, so if the engine isn't at idle, then it's not part of the problem.
What you ought to look for is whether this symptom occurs at a specific rev range; rather than speed, does it feel like the engine is bogging down around 2000 revs in all gears, or is it only at the speeds you mentioned?
The typical fault for low power is overfuelling; this is either dribbly injectors, or the Blue Temp Sensor:
http://www.e30zone.net/e30zonewiki/index.php/Blue_Plug
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
pcs
- E30 Zone Newbie

- Posts: 17
- Joined: Wed Jul 13, 2011 11:00 pm
- Location: Timaru, New Zealand
The problem has been there since I've had the car.
I should mention that I have recently replaced the head and head gasket etc as the original head managed to crack itself in 2 places.
Regarding speed/rpm question...if I'm at 100kph @2200rpm, and put it into 3rd gear and drive at 100kph at approx 3200rpm it improves significantly.
I've had the injectors removed and cleaned and they said that the spray pattern didn't improve much...more a squirt than a spray...
Have tried another AFM, been very careful about any airleaks, and have put in another blue temp sensor...
The stuttering is at its worst when holding at a steady speed or slightly deaccelerating - low load. If I put some load on the motor, it stops and accelerates away fine.
I've downloaded the Bentley by the way.......thanks
I should mention that I have recently replaced the head and head gasket etc as the original head managed to crack itself in 2 places.
Regarding speed/rpm question...if I'm at 100kph @2200rpm, and put it into 3rd gear and drive at 100kph at approx 3200rpm it improves significantly.
I've had the injectors removed and cleaned and they said that the spray pattern didn't improve much...more a squirt than a spray...
Have tried another AFM, been very careful about any airleaks, and have put in another blue temp sensor...
The stuttering is at its worst when holding at a steady speed or slightly deaccelerating - low load. If I put some load on the motor, it stops and accelerates away fine.
I've downloaded the Bentley by the way.......thanks
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Rebuilt injectors should flow and spray exactly like new ones, and I would expect them to come with paperwork to confirm it.pcs wrote: I've had the injectors removed and cleaned and they said that the spray pattern didn't improve much...more a squirt than a spray...
-
pcs
- E30 Zone Newbie

- Posts: 17
- Joined: Wed Jul 13, 2011 11:00 pm
- Location: Timaru, New Zealand
Hi Brian..........they didn't rebuild, just soaked and cleaned. Said the more squirt than spray didn't really matter as the cylinder diameters are quite small.....could the injectors be at fault tho' over such a relatively small range of rpm/speeds?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
pcs wrote:Hi Brian..........they didn't rebuild, just soaked and cleaned.
That's like cleaning and painting a second hand engine and claiming it's reconditioned!
Not much use to you, but there's a trader on here that does the job properly for £10 per injector.
You problem is most likely caused by duff injectors and/or air leaks, plus it's important that the throttle position switch switches immediately the throttle leaves its stop.
-
pcs
- E30 Zone Newbie

- Posts: 17
- Joined: Wed Jul 13, 2011 11:00 pm
- Location: Timaru, New Zealand
Thanks Brian......will check the TPS is functioning correctly. I thought I'd been pretty careful about airleaks, but will go over all that again. Sounds like I should have these injectors checked out, cleaned properly or replaced. Thanks
