The Problem is my 1988 325is will start in the morning and run all day long but as soon as I shut it off I can't start it back up for an hour or two.
The motor just cranks and cranks with no spark (used screw driver on block to test) . I can smell fuel and the fuel pump is running.
I’ve replaced the cap rotor, plugs, coil, plug wires and crank position sensor.
I’ve also swapped the DME relay with the fog light relay to test and that did not work.
Also I pulled the DME and it has a date of 2009 on it and looks new. So someone has replaced it. That doesn’t mean that it hasn’t gone bad again but I’m not sure.
The car was sitting for a long time when I purchased it but in great physical shape.
At first I had a high surging idle so I replaced.
Idle control Valve.
All Vacuum Lines
Throttle position sensor.
Brown and Blue Temp Sensors.
Throttle Body Gasket.
MAF Sensor
Also Timing belt and Water pump.
So the Idle is good but I still have a Check engine light (FF 2d)
for a temp sensor which is strange.
Sensor tests good but no voltage at the plug. I'll test at the ECU next.
But I don't think that's causing the no spark when the car is hot.
I don’t know where to go from here except maybe replacing the DME
Thanks for any help. And Merry Christmas






