power steering conversion ???

Need technical Q/A then you're in the right place

Moderator: martauto

gazwhittle
E30 Zone Newbie
E30 Zone Newbie
Posts: 181
Joined: Wed Nov 23, 2011 11:00 pm

Post Sat Dec 24, 2011 5:23 pm

hi all, if you read my earlier posts youll know im doing a power steering conversion.

Everything is on and bolted up ect, but now the wheels foul on the track rod ends.


I swapped my manual rack from a 1985 pre 316 for a power rack out of a 1989 316i. Is there any difference in the size of the racks and tie rods ect?

Everything is fitted right and the track rods measured and set so im confused now!
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Dec 24, 2011 8:14 pm

I'm confused as well! The track rod ends are bolted to the steering arms on the hub, which are presumably the same ones as you've always had, so there shouldn't be any changes here at all, unless you've fitted some grossly oversize rod ends.
The racks and tie rods are of similar dimensions, but aren't relevant anyway to what you're describing.
gazwhittle
E30 Zone Newbie
E30 Zone Newbie
Posts: 181
Joined: Wed Nov 23, 2011 11:00 pm

Post Sat Dec 24, 2011 9:20 pm

i know i dont understand either mate. ill get another look after near year and decide whats actually causing it. i just wanted to clear up that all racks , tie+track rods are the same length.
gazwhittle
E30 Zone Newbie
E30 Zone Newbie
Posts: 181
Joined: Wed Nov 23, 2011 11:00 pm

Post Wed Dec 28, 2011 10:45 am

right just had another look and it the splash guard catching. is there any variation in no ps tie rods and ps tie rods ?